Does this look right?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 6, 2004
Threads
123
Messages
859
Location
Lodge Grass, Montana
I pull the front wheel off for the first time - since the wife gutted a BFG/AT on her attempt to drive -

Is this how you all's 40 front end looks or is that a spacer?

Newbie question of the week -

Question two - does an 84/60 and a 79/40 have the same slave and master cylinder?
 
Last edited:
That's how the rotor bolts to the hub.

I don't think the 79 has the same master. The change was something like 8/80to a single res master for 40's and 60's the 79 i think would have a dual res. My 70 has the same master. I dunno about the slave.
 
What month 79-40 series...

The masters may very well be compatible, the slave cylinder on the wagon is different that the 40 series however...
 
Thanks guys - the master is single cylinder - the slave looks identical - October 79 then it was not sold until December 80...some dealership sat on my 40 for a long time...

I replaced/rebuilt the slave and master in the 60 yesterday - and then drove the 40 tonight and thought wow this could use a new slave.
 
The body/housing of the slave cylinder may be the same, but the acctuation rod in the 40 is adjustable, and apparently, the 60 series is not....someone posted that up out here a while back....


They should have compatible clutch master cylinders as well....



Good luck!


-Steve
 
I "think" 8/80 fj40 fj60 use the same slave and master, slave i recall on both not adjustible(from what I recall) or maybe its that they don't have a return spring.....oh hell I dunno ;)

Poser said:
The body/housing of the slave cylinder may be the same, but the acctuation rod in the 40 is adjustable, and apparently, the 60 series is not....someone posted that up out here a while back....


They should have compatible clutch master cylinders as well....



Good luck!


-Steve
 
Back
Top Bottom