Dead Radio?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 23, 2003
Threads
14
Messages
74
So the radio in the wife's grocery getter died.

Specs on the rig:
97 LX450, Stock, has cassette player w/CD cartridge in the center console accessed via the back seat (WTF were they thinking?).

She was out Thursday night & heard a pop when it stopped working.
I checked the fuses (both under column & by battery), none blown, did replace the 2 obvious ones to be sure.
Cigarette lighter, windows, & AC all work.

I'm wondering if there is a fuse-able link for the radio?
Are there other inline-fuses that I might have missed?

On a side note, the retractable antenna stripped it's gears last year.
I've been too busy/lazy to swap in the little kit for it.
However, today I noticed the antenna is down for some mysterious reason (we didn't slide it down).
 
Does the dome light work?
 
Dead as in no power/won't turn on.

Clock above it is fine though.
 
Do you have the premium audio system with 6 disc CD changer? If you do and the problem is your head unit, I have one I'm not using. PM me if interested.
 
I'm going to bring this back to the top.

Yesterday, I finally got around to installing the radio I picked up from Vik (alaskacruiser). Thanks again Vik.

It's still not working.
Vik, are you 100% sure the radio you sent me was working? (it looks brand new, so I'm guessing yes, just need confirmation so I don't chase ghosts).

I didn't have a V meter (loaned it to my Dad) & it was getting late/rain was on the way so I didn't have a chance to check the power wires on the pig tail.


Things that I'm guessing it could be:

Bad Ground-Does anyone know where the ground wire from the pigtail goes behind the dash? Does it just go to a body/frame panel somewhere?

Bad Fuse- I've checked & re-checked all the fuses, both below steering column & by battery. I may go pick up 2 packs of all new fuses & swap them.... I'll try & check for power at each fuse with a V meter or a light once the weather clears (Monday).

Blown Amp- I looked at the amp via the speaker cover & removing the box (looking to see if there was fuse on it), I didn't remove it, so I & all connections looked good.

Security Code in the radio- I'm not getting any power, so I'm guessing thats not it. Searches here state that "SEC" comes up on the LED for the radio, then it needs to be reset at the dealer.


EDIT- I should note, I really want to get this fixed because my Wife is driving me nuts about it.
 
You'd be able to narrow down your results fast if you get that voltmeter. Find out if you're getting any power on the line to the radio, that'll be a big tell.
 
Thats the plan for tomorrow.. I'll post up results.
 
Im just taking a stab in the dark here. But I think it could be your amp.

I am in the process of removing my aftermarket stereo and putting my stock one back and I have it all plugged but it is not working, showing the same symptoms as yours. but after reading this post I remembered that when i installed the aftermarket stereo I had to disconnect the stock amp. My hunch is that this is the problem. Will let you know if this works for me.

....and if not anyone have any other ideas?
 
This is an update of my earlier post...

I just plugged the factory amp back in and everything works great!

so getting back to your problem. It is ovbiously not a problem with your stereo unless you have 2 bad stereos. So I would check the amp connections or the amp itself, could be blown somehow...
 
OK, I finally got to spend some time trying to figure it out today. (weather & free time have not been in sync lately).

Using this diagram:
IH8MUD.com Forum - View Single Post - 1997 LX 450 radio install help!

I did some checking. Both grounds are good (checked them to the lighter).

I didn't get any power to the #4 terminal (Bat+).

I double checked the fuse in the engine bay & it's good.

I even pulled the wiring harness out, removed the bottom cover & checked for continuity there & it was good.
(That was a major PIA, I ended up pulling the battery & battery holder out to get access to it (it was stuck).

Anyone know where the #4 wire comes from?
 
OK, I finally got to spend some time trying to figure it out today. (weather & free time have not been in sync lately).

Using this diagram:
IH8MUD.com Forum - View Single Post - 1997 LX 450 radio install help!

I did some checking. Both grounds are good (checked them to the lighter).

I didn't get any power to the #4 terminal (Bat+).

I double checked the fuse in the engine bay & it's good.

I even pulled the wiring harness out, removed the bottom cover & checked for continuity there & it was good.
(That was a major PIA, I ended up pulling the battery & battery holder out to get access to it (it was stuck).

Anyone know where the #4 wire comes from?

According to my FSM it goes to EA1 (Gray 12 pin conector) cowl wire/engine room main wire which should be close to the black fuse box near the battery. Try to disconnect it and check the pins, as I recall, a friend had a problem with this connector because one of the pin was not firmly seated and locked on the socket base and when he plugged the male on the female socket you could see this wire terminal standing out and not be recesed as the others.

But as noted before, #4 is hooked to the 10A dome fuse. Check voltage before and after dome fuse.
 
Sorry I havnt posted this earlier, been waiting to finish my box build along with the drawer system. I tried to research the whole LX radio deal for hours one day on here. Come to find out it seems VERY different then the LC radio. Power doesnt come to the radio first, ALL the power seems to generate from the amp, even the power antenna doesnt work if the amp is disconnected and new radio installed, unless tapped into. The LX's doesn't seem to have the EXTRA grey harness right in the dash like the LC's do.

Anywho, I would bet that your radio is not the problem it is in your amplifier. I am pretty sure the sound she heard was a capacitor inside the factory amp, either it went and thats what did it, or when it went it might have thrown a power surge into the speakers. There is no fuse on the factory amp. You can unplug the factory amp and then put 12v and ground to the HU and see if it lights up, or just clip the power wire thats not getting power so you don't feed it back through the system and give it 12v's there if you dont mind cutting your factory wiring. you can make a jumper via the remote or a.k.a. ingnition wire to the back of the radio.

BTW if anyone needs to install an aftermarket radio in there LX, I have a very easy install just about anyone can do, and the install shouldnt take you more then 20-30 minutes.

This may not help ya for your situation, but if you dont replace the amp, and want to do an aftermarket, there is an EASY WAY. Or if you want to replace the amp, I do happen to have an extra amp, and head unit I would be willing to sell ya if your interested, or cant find one close by. If you want some help over the phone I can talk ya through it, just send my a IM and I will give ya my # to call.

Here's the best solution.....;)


DSCF0044.jpg


Jeremy :cheers:
 
I guess the wife would not like to loose the rear space when doing the grocery shop:grinpimp:
 
I guess the wife would not like to loose the rear space when doing the grocery shop:grinpimp:

Pretty much.

I ended up putting everything back the way is was without a fix because it began to rain. :(

Is it as simple as making sure there is power at the wire input of the deck?

I have a hot wire behind the dash is currently on a switch that goes no where.
I believe it was for fog lights that the PO removed.
I could ad an inline fuse & tap into the harness.
 
Vik, are you 100% sure the radio you sent me was working? (it looks brand new, so I'm guessing yes, just need confirmation so I don't chase ghosts).

Hi MochaMike- sorry I didn't catch this thread until now (you should have PM'd / emailed me about this, as well). The head unit I sent you was working perfectly when removed from my truck. Lemme know if you have any probs with it, though. Hope you get this fixed!
 
Pretty much.

I ended up putting everything back the way is was without a fix because it began to rain. :(

Is it as simple as making sure there is power at the wire input of the deck?

I have a hot wire behind the dash is currently on a switch that goes no where.
I believe it was for fog lights that the PO removed.
I could ad an inline fuse & tap into the harness.

It would be nice the get a look at the Lexus wiring diagram as to see what´s different to the LC wiring.
 
Back
Top Bottom