DC Tatton Drive Front Drive Shaft

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 15, 2013
Threads
64
Messages
1,977
Location
Ashland, MO
I need to get a dc front drive shaft. Local shops are expensive. I called tatton and was quoted 350 delivered. I wanted to see if any of you guys have a long term review(s) Pros and cons. Thanks!
 
Should be able to source a shop locally for less than that...
 
Call a couple local auto repair shops and ask if they have a driveshaft balancer (they likely won't). When they say no ask who they send them to. That place will likely be able to build one. Worked in my case at least.
 
I've had my Tatton front DC shaft installed since last summer (probably have about 8k miles on it). Zero issues. Fit perfectly and eliminated my vibrations. No complaints.
 
I have a Tatton DC rear with 10 k or so on it now and it's just fine. The only local driveshafts shop in Richmond, VA told me it was impossible to build a Toyota shaft with spicer parts. I chuckled and called Tatton. Great customer service and quick shipping.
 
Curtis at Tatton is a great guy to deal with. No issue with any of my dc shafts.
 
I've had a Tatton front DC for 6 months now. I love it. Zero issues. I think it took about two weeks to come in.
I live in an area where custom drivelines, machine shops that have seen a 1fz head and people who know the difference between an LC and a 4Runner don't exist....so, I had to mail order.
 
I have had a Tattons for almost 4 years. No problems. If you search Tattons on here you will get some results. I asked him initially to build me a Tacoma rear shaft, but shorter. Had a minor issue at first. However Curtis made it all good.
 
4500+ miles on tatton and no complaints. Grr is gone . 315s slee
Plates and j springs with arb and m12000. Stock driveline was not
Happy at 50-60mph. No issues since and weekly drive at 70+ for 90miles each way. I love my weekenders


...via IH8MUD app
 
Wasn't there a big group buy on these a while back?
I seem to remember a lot of fitment issues due to the flange thickness of the Tatton shaft.
If I recall correctly, the Tatton shaft had thicker flanges and there was difficulty bolting to the studs on the transfer case. The studs were too short and the flanges had to be re-machined to make it work right.

Make sure whatever you decide that the flange will bolt up OK. Those studs would be a real pain to replace.
 
IIRC, Tatton made good on the thickness problem. Sounds like a good vendor to me. I was following this group buy pretty close as I needed a new one about that time. Got my local shop to fix me up for similar $$.
 
Tatton DC Here as well, 10k on it now, no vibs anymore. Wouldn't hesitate to do it again especially after the thickness debacle and his response to it. Good price and great customer service.
 
My hole pattern was drilled incorrectly. I let him know. He offered to pay for a local shop to install the new flange. I told him I could do it. He sent a new flange with a extra U joint incase I screwed it up swapping them.

That was pretty good service in my book.
 
Back
Top Bottom