Cylinder head advice needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 18, 2009
Threads
144
Messages
1,109
Location
Modesto, CA
I just bought a 97 LX. It has a blown head gasket which was confirmed with a compression test earlier this week. This is the second time that the head gasket has blown in 3.5years and only 38k miles. I've ordered a majority of the parts needed and many "while your in there." I have very little experience working on engines and I hope I hose with more will chime in.

Since this is the second time blowing the HG and not knowing if the vehicle was overheated (I was told it wasn't) should I go ahead and get another head and get it machined instead of waiting for mine to come off? Should I go ahead and get the valve guides now or wait until the head is pulled?

Any advice is appreciated. Happy Father's Day.
 
Reciept from last rebuild.

image.webp
 
No way to know without having yours checked really. I wish I had a known good head for you but I sold my last one a few weeks back.
 
Looks like the head was rebuilt and surfaced, hard to tell what went wrong until it's off. What is it doing, unless it's blown between cylinders, a compression test is a poor way to confirm a blown gasket.
 
Code po300, 305,306. Misfiring badly but still ran. Coolant was nearly gone. There was no sign of contamination in dip stick. I think although I'm no expert that it blew between 5 and 6. Here's the plugs.

image.webp
 
Just found out the engine was rebuilt in 2012, 1 year before the head was redone. I'll post receipt shortly. I contacted PO and he confirmed that the engine was rebuilt. Sounds like they had to sleeve a cylinder.
 
Do you intend to do most the work yourself? If so, do you have another vehicle to use while this one is down? Do you know how much they took off the head the last time it was machined?
 
No idea how much they took off the head. Just what the receipt says "resurfacing." I've got another head and cams to use but they are missing some parts that I would have to transfer if the original is bad. I'm not going to do the work but I wish I had the time and skills. It's likely going to valley hybrids in Stockton, CA in August for the work. Although it would be nice to get it done sooner -- volunteers are welcomed. In the meantime, I've got an 06' LC as my DD.

image.webp
 
Back
Top Bottom