Cutting rockers, Which tool?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 7, 2003
Threads
295
Messages
2,786
Location
Cincinnati
I'm cutting my rockers for some Faultline sliders. These are tools I have Sawzall, jigsaw, circular saw (big one or little one)
Do I just unbolt the the bolt at the seams @the front and back wheels and leave it go?
And move the brake line out of the way on the passenger side?
Is it bad to cut rust free rockers :D well at least one side has some rust.
 
a masonry blade in a circular saw gives you good control to make straight lines, but it's hard on the saw.
 
Since I was trying to salvage/reuse the paint on my rockers, I used a jigsaw. Sawzall would have been fine as well, but the longer blade was just asking for trouble flapping around behind there.

The problem with friction cutters (cutting wheels) is that the metal is thick enough that it gets really hot - enough to burn and/or bubble the paint right off. If you were going to repaint anyway or didn't have paint, I'd go that route as you get better lines and control.

Don't use masonry blades on metal. There are metal-cutting blades for your circular saw on the peg right next to the masonry ones.

And for goodness sake, it's sheet metal and the line needs to be somewhat straight - don't even think about a torch unless it's attached to a plasma cutter.
 
Sawzalls are used during attack and destroy missions. I saw one used with a different attachement at the colorado river on someone, you can guess what they attached, interesting to say the least. :censor:

I really like using a jigsaw for thin body work. If you are good with the scroll you can even make really nice curves, easy to also hold a straight line with a guide. I was amazed at how clean the cut was the first time I used one on my cruiser.
 
They will all work, but since it is a straight cut, I would go with the Sawsall with a 18 to 24 TPI bimetal blade to make short work of it. If you are going to trim the fenders or cut curves, the jig saw does a good job because it is easier to control.

snailwagon said:
Sawzalls are used during attack and destroy missions. I saw one used with a different attachement at the colorado river on someone, you can guess what they attached, interesting to say the least. :censor:

.

Hmm. I'm having trouble visualizing this. Can you explain in more detail?

:popcorn:
 
Back
Top Bottom