cranky electric windows

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 9, 2017
Threads
366
Messages
2,589
Location
tejas
gents,
it’s 42 degrees F here - nothing to complain about and i’m not sure if it went down to freezing overnight or not.
but my DS and PS windows went down and wouldn’t come back up. after holding it for awhile they /eventually/ are now back up.
the driver’s side has been pretty slow since i got the vehicle.
am i looking at replacing both motors if i get in and do the speakers?! can i lube them somehow? is there a way to troubleshoot this or is this basically all i need to know for replacement...?
THANKS
 
Last edited:
I would love to see if there is a way to change out the motor. Have the same issue
 
Its the runners in the window frame. All the felt is probably worn off.
 
Clean the runs out with an air hose. They get stiff and full of dirt over the years. Gotta do all the way to the bottom inside the door. Grease up the linkage while your there.
 
My windows get s***ty in the winter also. It's the runners, no felt and hard cold rubber love to grab glass.
anyone got some kind of 3M product for replacing it i wonder? at least i know to wait until things warm up!
maybe some goo gone to get the old stuff on and smack on some new felt...? or probably a whole lot more trouble than that...?
 
At minimum you have a 22 year old truck and max a 28 year old truck. If you want your windows to work well in cold temps only solution is the replace the window runs and the motor if it’s still original. That’s been my experience. Not cheap but what is on an 80 series.
 
Just replaced the DS motor on my 95. Dorman makes the motors(742-601 LF/RR, 742-600 RF/LR), fit great, easy to install and makes the windows run like new again. Clean and lube the rollers and tracks while apart and clean the contacts in the switch for best results.
 
When you guys say the runs need to be replaced what are you refering to specifically ? The one that goes around the sides and top or the horizontal ones ?
 
When you guys say the runs need to be replaced what are you refering to specifically ? The one that goes around the sides and top or the horizontal ones ?
Toyota calls it window glass "run channel" and can be ordered from any dealer. They are door specific and are easy to replace.
As previously stated, all the rubber bits on your truck are way past their prime and should be replaced. Almost everything is still available new from Toyota.
 
Clean the runs and spray silicone or/and rub in some SylGlide or Gummi Pfledge Stift. Mine go up and down just fine and I can almost guarantee that it gets colder where I live than where you live. ;) It's -20F right now.

I was going to buy new runs, but upon closer inspection, mine were just dirty and dry. If the rubber is sun beat and crusty, that's another problem that can be solved by installing new runs, but I would try cleaning and lubing before I dropped a bunch of money.

The motor swap threads seem to indicate that the runs still need to be clean and lubed for the windows to operate properly, so the logical place to start is there anyway.
 
Toyota calls it window glass "run channel" and can be ordered from any dealer. They are door specific and are easy to replace.
As previously stated, all the rubber bits on your truck are way past their prime and should be replaced. Almost everything is still available new from Toyota.
Very true for many people, especially out west. In the north, our paint and rubber stays fine if the truck was stored indoors. At least mine was.

I would try cleaning them first, but if that doesn't work, your advice on the new runs is spot on.
 
Back
Top Bottom