Cooling system flush question...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 25, 2007
Threads
67
Messages
591
Location
Winter Park, CO.
Hi,

I am going to do a major flush of my cooling system along with some PM stuff (PHH, etc...).

I read somewhere on here about a method of flushing the system by draining it, then filling with distilled water only, running it for a few minutes, then drain and repeat a few more times.

I can't find the thread anymore. I am search challenged sometimes:doh:.

I want to use this method because where I live the water is soooo hard, I'm concerned about mineral deposits left over. Also, I'm anal.

Has anyone else here done this method?

If so, how long did you run the engine with just water in it?

Thanks, Dace
 
Here's the thread I used a reference when I did mine: https://forum.ih8mud.com/80-series-tech/8905-radiator-flush.html

I may be wrong but without using a hose and tap water, you're going to go through tons of distilled water. I ran mine for what seemed forever with a hose connected and old coolant still came out everytime I opened the petcock on the radiator, which I did over and over to verify that I had completely flushed the system.
 
I've read those and they look great, but still can't find the thread I'm looking for...

Maybe I'll just have to got that route?

Hmmm...
 
I've used a small recirculating pump to flush tankless waterheaters (white vinegar followed with fresh water flush) and I'll bet that one could be used to flush the radiator with distilled water.

Fill the 5 gallon bucket with distilled water, drop the intake hose into the bucket, output hose attached to the hose to be flushed of your choice and then turn it on. Would have to take care to not overpressure any components. I'm thinking of trying this because our water is very hard well water.
 
i recomend removing the thermostat. It saves a lot of time because you don't have to wait until thermostat opens. Also it leaves the system wide open and I think that would help on the flushing because of better circulation

Removing the t-stat takes 5 minutes
 
i recomend removing the thermostat. It saves a lot of time because you don't have to wait until thermostat opens. Also it leaves the system wide open and I think that would help on the flushing because of better circulation

Removing the t-stat takes 5 minutes

flushing the rad is a good time to R&R the thermostat too
 
A little trick that I have used for quite some time and is used by the major company/dealership that I worked for was to use powdered Cascade dish detergent. I kid you not, this stuff works.
Drain all the old coolant out of your system including the block drain plug. Close the system back up, and about a 1 1/2 cup of the powdered goodness into the radiator cap fill hole and fill the system back up with tap water. Run this for a couple of days, then drain it as mentioned above. Fill back up WITHOUT Cascade and run for a couple more days. Do this about a total of three time and your system will be cleaner than ever. Once flushed, drain it as mentioned, fill with water and coolant with a bottle of Waterwetter and done. You may want to change out your thermostat prior to final coolant add.
Note: this will clean out a system very well and can clean out any debris that may be keeping the system from leaking i.e the water pump shaft seal. I have had to replace several well used water pumps several days after doing this. And not just on toyotas.
 
Thanks all! I just finished the job and it was a success!!!:D
 
Back
Top Bottom