Code 26 problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2018
Threads
35
Messages
140
Location
Houston, TX
1993 FZJ80

I deleted the PAIR system about 2 months ago. On Monday, it was raining and I went through a couple large puddles. In the afternoon, Code 26 illuminated and the idle was rough. I pulled the EFI fuse to reset the light.

I've driven ~70 miles since resetting the light, highway and city, and the CEL hasn't come back on. But the idle is rough, it hesitates off the line, and hesitates and shakes at 40 mph.

I'm thinking the O2 sensor wiring got dirty from the water puddles, but open to other suggestions.
 
That’s the first thing that comes to mind. I’d pop the connectors off. Dry, clean and add some dielectric grease to them. Did water make it into the engine bay?
 
That’s the first thing that comes to mind. I’d pop the connectors off. Dry, clean and add some dielectric grease to them. Did water make it into the engine bay?
No. I'm going to go ahead and put in new o2 sensors. I removed the PAIR system and will move the o2 sensors to manifold anyway. Can I bypass the connectors and hardwire them? The new Bosch ones have a fancy electrical connector.
 
I own a 94 and had a problem with a ruff idle, below is a link to the problem i found with the O2 sensor. Start by reading post 13 in that thread, the answer to your problem is found there.
 
Last edited:
Yea I think rifleman is correct.

If it’s a side by side cat truck like mine one of the 02 sensors connectors is pretty much in the wheel well, kind of a bad spot. When I put my new sensors in I put grease in the connectors and put heat shrink insulation over it.
 
No. I'm going to go ahead and put in new o2 sensors. I removed the PAIR system and will move the o2 sensors to manifold anyway. Can I bypass the connectors and hardwire them? The new Bosch ones have a fancy electrical connector.

Not sure on the hardwiring,
But don’t go with the Bosch. You’ll continue to throw that code if you do. Get the Toyota branded sensors. They cost more but will last longer. Trust me I went through sets of every Other aftermarket brand ever year or two years before I got these. I wasted tons of money.
 
I bought sensors for my 93 from the Toyota dealership about a month ago. The parts guys said Toyota had 2 sets left in the U.S. for the side by side cat trucks, and I paid out the butt for 1 of them. So explore other options for sure first.
 
I believe it's NTK for 93-94. I too wasted time and money replacing before buying the Denso brand for my 96. Now I'm at about 40k miles or more without another problem.
 
Back
Top Bottom