clutch slave size?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 27, 2005
Threads
183
Messages
471
Location
San Jose CA
ordered a slave rebuild from SOR. They were out of stock, so they sent me a new slave. Tried to put it in but ran into a few issues.

The old slave and hydraulic flex line have been in the car for at least 20 years.

The hydraulic line is an 11 mm size. And the ends don't swivel (at least the one I worked with).

The new slave has a different size fitting, a 10 mm. Bummer.

Anybody run into this before?
 
Year?

I had a braided SS line made 27 years ago. The industrial shop that made it, as with others, can make anything under the sun. Bore and stroke are the most important factors... lines can be made.
 
Double post
 
I just looked into this same issue this morning. I bought a new slave cylinder from Mark's Off Road for my '71 FJ40 build and picked up a new aftermarket hose from NAPA on Friday afternoon. Last night I tried to thread the hose (with 10mmX1.0 threads) into the slave, but the end of the hose just slipped in. I looked at the Cruiser Outfitters website this morning and discovered that the earlier clutch slave (through 7/70 IIRC) has 11mmX1.25 threads. I must have ordered the wrong one. It's brand new and still in the bag. Do you want to swap? I can mail mine off tomorrow.

Mine didn't come with the rod, nut, and lock nut, but those didn't change in 7/70. I refurbished mine, so I can still use them. You could keep the new rod, etc. if the one you bought from SOR came with those.
 
Last edited:
I forgot to ask, is the mounting hole spacing 45mm? That's the spacing on the slave I got from Mark's Off Road.
 
after carefully looking at my clutch 'system', I've decided to just replace the whole thing. Apparently the 'package' of master, slave and connectors has the parts for the driver's side slave only. Mine is on the passenger side. Some PO extended the hard line with two pieces
and multiple connectors. I'm going to replace the very aging flex line and those multiple connectors with a more reliable single length custom hard line (wish me luck) and a steel sheathed flex line.

so, no go on swapping the slave with 4Cruisers...sorry
 
after carefully looking at my clutch 'system', I've decided to just replace the whole thing. Apparently the 'package' of master, slave and connectors has the parts for the driver's side slave only. Mine is on the passenger side. Some PO extended the hard line with two pieces
and multiple connectors. I'm going to replace the very aging flex line and those multiple connectors with a more reliable single length custom hard line (wish me luck) and a steel sheathed flex line.

so, no go on swapping the slave with 4Cruisers...sorry
No problem at all. Sounds like you've come up with the best plan.
 
Any auto parts store will have 3/16 brake line with the correct 10mm fittings. I used this to extend my hard line to the passenger side when I switched to 4 speed along with the V8 in my '74...
 
Back
Top Bottom