Clutch master/slave question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 3, 2014
Threads
11
Messages
38
Hey All,
Is the bore diameter of the clutch master and slave cylinders supposed to be the same? My master is 3/4" and the slave is 13/16". The stroke seems to be slightly limited and I think it is not quite releasing all the way. This is a complete resto with all new/rebuilt components, properly bled etc. My understanding is the 3/4" was just older FJ40s ('66 and back?) but was that just the slave? All the slaves available for my year ('77) are 13/16" but I am not sure about the master.
Thanks
 
The bore of the masters and slaves varried over the different years. SOR used to list the diameters on their site... last time I looked I couldn’t find them.
 
Last edited:
I no longer remember, or have the notes, but I do remember 3 different Landcruiser diameters, all under 1", I believe 3/4", 7/8", and 15/16" (but in metric sizes). Also, you had clutch pedal pressure issues if you mis-matched master & slave cylinders.
 
Thanks All,
Yeah - the sites show some pretty conflicting info. No doubt the 3/4" master is right. Just can't get consistent info on the slave but all the suppliers seem to sell the 13/16" slave. I did find a new 3/4" slave a while back which I have but the hydraulic line connection is too big for standard hose. Tried to find an adapter for it or different hose but no joy there yet. The mystery continues.
 
3/4 = 12/16 a 13/16 slave is only very slightly larger. I don't think you would notice much difference.
 
Back
Top Bottom