Changing rear wheel bearings difficult?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

No, not at all difficult just follow the specific steps in the FSM and refer here for the threads on the one nut that sets the preload. Ohh, I'd order all the parts from cruiserdan in advance including the four extra screws that sit in the locknut and perhaps another axle seal just in case you mess one up. HTH. :cheers:
 
Also requires an SST to be purchased or fabricated to remove the locking ring. But is and relatively straight forward job.
 
For the $50, I really recommend buying the SST for the job. It makes the job really easy. Only other point worth mentioning is to remember to lock the diff if you have lockers.... before removing the axle from the diff.
 
Does anyone have the section of the FSM that they could email me? Also is there a pic of the SST so I can see what you guys are talking about?
 
Actually, you can find at least one, maybe more write ups on this in the FAQ section:D
 
I think I had a bum tool , on the first torque one of the fingers busted off inside the recess :doh:

I wonder if American Toyota does tool returns?:cool:
ken
 
I broke my rear SST as well. Not hard to do.

Beowulf was nice enough to have it welded back together for me though!

Rear axle job is real simple stuff...even for a novice. If you need any helpl, feel free to PM me.

Cheers.
-onur
 
Back
Top Bottom