Center lock & Tranny?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2003
Threads
323
Messages
5,695
Location
Southwest Oregon
Just curious what to expect to find if my center lock light doesn't come on after driving around in "4L" for a couple hundred feet on a gravel driveway. After searching it looks like my ABS and Center light should come on. Bad light bulb? Bad locking/coupling? Corroded connections somewhere? Lack of use problem? It is really hard to shift into "4L" as well. I did notice some orange silicone on the X-fer case seams so maybe it has been opened up before. I think this was mainly a highway rig and still has the stock running boards with no signs of damage not that they didn't use or abuse 4L. My rig has 230k,no axle lockers, the production/delivery date was 12-26-92 and the dang tags were removed pre theft-recovery So I don't know if it has the A442F or the A440F. I have no button that I have found for the center diff lock. which I assume is because I have ABS(?).
Is there any visible differences on the tranny or numbers somewhere? TIA, Kief.
 
Typically its either the cable, loose connector or switch module at the Tcase.

You should be able to hear it engage and disengage if it is working.
 
Most likely it's a lack of use thing. I'd be sure all the fluids are full and clean, then merely engage and disengage low range a few times a week/day in hopes the use will clean the tip off the contact switch in the transfer case that tells the ABS to turn off and the proper lights to light on the dash. If this doesn't do anything, then try pulling the center diff lock switch which is somewhere high on the right side of the transfer case. It pulls out and you'll find a simple pin switch easily cleaned and reinserted. A search will find this, as well.

DougM
 
Kind of what I was hopin'.. We will probably pull all the interior out and give it a serious detail... don't know if that will be accessable from the tranny cover or from underneath.
GEE WHIZ, there is a lot of stuff on these things!
 
Who said anything about pulling the entire interior out?? Lay down some cardboard, slide under and pull a single screw (maybe two) to pull this thing out so you can clean it.

DougM
 
OK, OK... I think I would have tried getting at it from underneath first...


Any thoughts on finding the tranny type?
 
Any thoughts on finding the tranny type?

See where the pic says A343F? That's the transmission code for your truck. Tell us what it says on yours and someone can ID it for you.

Also check out Slee Offroad's technical page. Lots of info there, including tranny types by model year
80 Series Data Tag.webp
 
Last edited:
Who said anything about pulling the entire interior out?? Lay down some cardboard, slide under and pull a single screw (maybe two) to pull this thing out so you can clean it.

DougM

I have the same problem with my 80.

What side of the truck is this switch on? 11 O'Clock position from what direction? P/S or D/S? Front side or back side?

Thanks,
 
See where the pic says A343F? That's the transmission code for your truck. Tell us what it says on yours and someone can ID it for you.

Also check out Slee Offroad's technical page. Lots of info there, including tranny types by model year

I ain't got no label... The thieves stripped every vin# off every door, fender and the body, including that one. It does have "Toyota" still on the door where it was.
I checked Slee's sight, very informative but it didn't state specific dates and unless Toyota changed I am sure there was some blur with newer models getting older parts and vise-versa.
I was curious if there was some obvious features on the exterior of the tranny. It works, knowing which model it is falls into the trivia category for now.
Thanks.
 
I found a blue tag with a Aisan Seiko serial # 2K 1515 . Judging by slee's site it would have to be the A442F judging by everything else that happened at that time- ff rear, abs Etc. that it has.
 
Back
Top Bottom