Center Dash piece

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 12, 2006
Threads
67
Messages
1,380
Location
San Diego
Has anyone replaced this dash piece?

dash.jpg


I took a quick look and it doesnt' look to bad, but it also looks like there could be some surprises. I want to remove the aftermarket wood that I've hated since the day I installed it 5 years ago. Can anyone give me a banana count?

I wonder if anyone in here might know the part number and price....
 
Dealer #32 (or higher ;) ) guesses that to be a 55412-60010.

You need ot be a bit of an acrobat to get it out without breaking it. The switches are a bit of a challenge and the heater control will come out attached to the back of it.

The current suggested list price is $107.00.
 
Yeah I ordered a new one after the theives that took my stereo destroyed mine:

part no. 55412-60010
mine was about $100 (can't remember the exact price)
 
If you're just removing the wood from the plastic piece, just run the truck with the heat cranked inside the cab for 20-30min. It'll peel right off.

Before installing the wood, the instructions said to rub down the plastic with rubbing alcohol. While it sure did make the adhesive work incredibly well, it also discolored the plastic.

My "D" light burned out, I want a new double din stereo, and I need to install new dash switches for my lighting in unused locations covered by the wood. The planets are all aligned for a new non-screwed-up center dash trim piece.

I figure for $100 it will make the truck look considerably newer too. I replaced the center console for the same reason, and it really does keep things looking show-room ready.
 
I've had mine off a couple of times now, no problems. Just don't force it.

Biggest PITA on mine was diconnecting the two heater molex connectors; they were stuck and there's not a lot of finger room behind the heater.
 
Before installing the wood, the instructions said to rub down the plastic with rubbing alcohol. While it sure did make the adhesive work incredibly well, it also discolored the plastic.

My "D" light burned out, I want a new double din stereo, and I need to install new dash switches for my lighting in unused locations covered by the wood. The planets are all aligned for a new non-screwed-up center dash trim piece.

I figure for $100 it will make the truck look considerably newer too. I replaced the center console for the same reason, and it really does keep things looking show-room ready.

I thought I was the only one who went around interior trim cause it didn't look nice. ;)

I think Dan loves my addiction... wife on the other hand...
 
The 80 dash is probably the worst dash I've come across to remove... taking the dash off my 300ZX is a piece of cake compared to the 80.
 
The 95-97 80 dash, after looking at that diagram, looks like it's much easier to take apart than the 91-94 dash. I would wager that it's more like the 300zx as far as taking apart goes.
 
The 80 dash is probably the worst dash I've come across to remove... taking the dash off my 300ZX is a piece of cake compared to the 80.

ah... no.

Hands-down the worst das to dis/reassemble is the 90-95 minitruck/4Runner.

Imagine the LC dash in 3/4 scale, and with sharper edges and more screws.
 
Back
Top Bottom