CEL won't reset? At all????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 28, 2015
Threads
11
Messages
133
Location
Lewiston,ID
I am throwing a CEL for #1 O2 sensor (Can't remember the # off hand, but 28 maybe?) '94 OBDI, recent rebuild, fairly new sensors in the manifold where I deleted the PAIR system. first 1000 miles after the rebuild was fine, no codes.
Anyway, I've tried clearing the code so I could start narrowing down if it is the sensor, a wire, etc. Problem is, it won't clear. I've pulled the EFI fuse, pulled battery cables, but light does not go out. It's just on immediately when I start the engine.
Any thoughts?
 
Doesn't pulling the battery cable off clear the CEL? It does on my '95. It comes back after the engine runs it's diagnostics, but at least it puts the light out when I first start the truck. If you fix the issue, the CEL will clear the next time the test completes.
 
That's the problem. It's supposed to clear it. But it won't. The light just stays on.
 
My guess is that it is resetting but then immediately determines there still is a fault. I think that will occur is the heater circuit in one of the O2 sensor fails. First I would check all the wiring to make sure it hasn't shorted, broken or come in contact with the exhaust manifold. If you have the old sensors plug them without installing them and see what changes.
 
What ^^ PPC says. A hard fault will not clear. Repair system and then clear the code. Perhaps try unplugging it and then see if you can clear it, temporarily.
 
Just a thought, have you tried pulling the EFI fuse, letting it sit overnight to cool completely, and then tried starting it? If the problem is related to a hot sensor, the code may not ever clear long enough for you to chase it down.
 
You may also have a short in the O2 wiring causing an immediate code. If you melted through or chafed through multiple wires and they're in contact you could have nasty short. Check the wiring behind the glovebox and around the EGR valve.

Oh and a quick plug, if into turns out you managed to toast the ECU or yours is just faulty, I have one for sale for a 94.
 
Back
Top Bottom