CDL Questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 9, 2008
Threads
52
Messages
203
Location
Northern CA
I have a 1994 Land Cruiser w/o lockers and just installed the CDL switch. I have not done the 7-pin mod yet but will do it, later. Please, help me with the following questions related to my LC:
1) What is a safe speed to push the CDL switch? Is there a max speed? I know it's hard to turn once the CDL switch is engaged so.
2) I don't go off road with my LC but a drive to Tahoe on I-80 or Hwy 50 in the snow is probably the worst condition. Should I use the CDL in this scenario, within the max speed?
3) What are some off-road conditions which using the CDL is ideal?
I have read so many threads on this but with so many different answers so please keep the answers related to my 1994 LC w/o lockers. Thanks for your input.
IMG_2190.jpg
 
Push it whenever you like, as long as it isn't when one axle is spinning under load and the other isn't---i.e. stuck in a ditch and on the throttle. It will operate much like any other shift on the fly system out there. Keep in mind that you lose your ABS, so just be comfortable braking in 4wd with no ABS--Some folks have reported shorter stopping distances on snow with the CDL locked, but YMMV. You can run as fast as you want.

The CDL will give you normal 4wd instead and eliminate the center diff (transfer case) slipping off road. Use it in high range when you need wheel speed but not torque--Sand, snow sometimes, gravel roads etc. Low range for ascending or descending steep hills, going over obstacles etc.

Unlock it in low or high range off road to help with turning--this keeps the tires from binding up on rocks and/or digging into sand on sharp turns.
 
I travel the same highways to Tahoe and I think that you would be fine to leave it in "normal" unlocked mode for travel when snow is present on 50 or 80. This is the mode of operation toyota felt would be good for high range driving here in the US where roads are generally much better than other countries. CalTrans shuts the road down and requires chains before the 80 series is challenged by the snow anyway.
The moment you enter the "off road" arena, lock it.
 
Thanks for the information, baldilocks and KliersLC.

I've gone up I-80 and Hwy 50 when chains were required with no problem but now that I have installed the CDL switch, I wanted to know how I can use it, if needed.
 
I'd leave it unlocked when using chains, you'll have more than enough traction. Lock it up when leaving the plowed road though.
 
I'd leave it unlocked when using chains, you'll have more than enough traction. Lock it up when leaving the plowed road though.

Sorry. I never use chains on my Land Cruiser going up the hill. I have taken my 1991 Civic up the hill with chains and it's not fun. Love driving by people getting out in the cold to put on chains.
 
Thanks for the information, baldilocks and KliersLC.

I've gone up I-80 and Hwy 50 when chains were required with no problem but now that I have installed the CDL switch, I wanted to know how I can use it, if needed.
Some things are learned through experience. And always remember that opinions vary widely when you ask an opened ended question here on the mother of all Landcruiser sites. Go play with it and form your own opinion. It will be fun too.
 
Last edited:
I thought going up to Tahoe when it's snowing you either have to have chains or AWD, not both. Has the rule changed lately?
 
I thought going up to Tahoe when it's snowing you either have to have chains or AWD, not both. Has the rule changed lately?

Yup. 4x4 or chains, not both. That's why I love driving my Land Cruiser to Tahoe for snowboarding. Can't wait for the first snow storm with fresh powder!!
 
I have a 1994 Land Cruiser w/o lockers and just installed the CDL switch. I have not done the 7-pin mod yet but will do it, later....
I have same year rig w/ lockers also and will try to help.
1) What is a safe speed to push the CDL switch? Is there a max speed? I know it's hard to turn once the CDL switch is engaged so....
KliersLC pretty much answered this, but did not mention that with out doing the Pin-7 mod, you cannot unlock the CDL in lo-range. Computer auto engages CDL in lo-range and is main reason for mod.
2) I don't go off road with my LC but a drive to Tahoe on I-80 or Hwy 50 in the snow is probably the worst condition. Should I use the CDL in this scenario, within the max speed?
3) What are some off-road conditions which using the CDL is ideal?....
To answer both these questions you need to understand the Viscous Coupler (VC), which comes with the '93 & on 1FZ equipped auto trans 80s. It is in the Center Differential, commonly called transfer case by most 4x4 folks. It is a limited slip device for the drive shafts. Designed to aid in traction in high range, since the CDL switch was now removed. Biggest downfall for the VC is it heats up when the drive shaft speeds differ due to continous low traction. In other words, when you're in high range, if you find yourself, for example in icy conditions, deep mud, or anything where you're getting a lot of wheel spin - engage the CDL. The VC is a simple & tough little contraption, but when over heated too many times, it can seize up and stop allowing slip between the drive shafts. This is like having the CDL constantly engaged - like running in 4 - lock in a normal 4x4. Once the VC seizes up, it's history. Replace or just remove it. There's threads on here to help with that.

In summary, if in doubt - engage CDL - it won't hurt, but don't be too hard on the throttle when you engage. When you get back to normal conditions - dis-engage it. One note, that I might add: Sometimes when you're at a dead stop and you hit the switch you need to move the rig just a little before it will engage and light comes on. Same with dis-engagement. If drive train is really bound due to being left engaged on high traction surface, you might need to alternate Drive & Reverse a few feet. I also like to engage and dis-engage a couple times a month when rig is warmed up, just to exercise the switches and solenoids. Common problem with malfunction is parts binding up from lack of use.
 
Last edited:
I like to engage the CDL on roads where traction is not consistent like going through drifts, icey or melting paches where the tires on one side may have consistent traction and the other side is constantly changing. Best thing is test all options as every one has different preferences/styles and conditions change depending where you live or travel. Do not use on dry roads as you will get windup in the driveline. The tires need to slip to eliminate windup.
 
Thanks for all the helpful information provided. Love being a IH8MUD member!
 
The CDL will give you normal 4wd instead and eliminate the center diff (transfer case) slipping off road. Use it in high range when you need wheel speed but not torque--Sand, snow sometimes, gravel roads etc. Low range for ascending or descending steep hills, going over obstacles etc.

Like the OP, I have questions about optimal use of the Center Differential Lock. I installed a dash-switch in the '93 several months ago and I occasionally engage the CDL on dirt roads to keep it in shape but have not needed it yet. My question is about a snowy or perhaps icy paved highway. Isn't torque preferred over less torque in these conditions? What, more specifically, is meant above by "snow sometimes"?
 
OK, just found the thread, "Ideal 4x4 settings for snow . . ."

Back later.

 
Like the OP, I have questions about optimal use of the Center Differential Lock. I installed a dash-switch in the '93 several months ago and I occasionally engage the CDL on dirt roads to keep it in shape but have not needed it yet. My question is about a snowy or perhaps icy paved highway. Isn't torque preferred over less torque in these conditions? What, more specifically, is meant above by "snow sometimes"?

"Snow sometimes" is referring to wanting/needing wheel speed or vehicle speed for your conditions--getting a run at a drift, keeping speed up to get through a deep section of snow, driving on a snow covered highway, etc....
 
In the thread alluded to above, seems most agree that on a snow covered highway best to not lock the center diff. Snow conditions like depth, highway straightness or lack thereof, and other factors should influence decision to lock or not. Once off-road in snow, most agree it's time to hit the CDL switch.
 
In the thread alluded to above, seems most agree that on a snow covered highway best to not lock the center diff. Snow conditions like depth, highway straightness or lack thereof, and other factors should influence decision to lock or not. Once off-road in snow, most agree it's time to hit the CDL switch.

As you said, lots of variables to take into consideration. For me, I prefer the cdl when there is accumulating snow on the highway. If freshly plowed or icy, I'll take the ABS.
 
I know this is an old thread guys, but wanted to clarify.

When they say there’s no ABS, does that mean with the CDL installed or when the button is pressed?

If I understand correctly, the pluses for installing the CDL is to prevent wear on the VC from potentially destroying itself from heat and also to better fuel economy.

The reasons for not installing is to preserve all the advantages of AWD (works in high traction surfaces like paved roads and intermittent ice patches)...do I understand that correctly?



Thanks, Rick
 
When you engage the central differential lock the ABS will turn off automatically. It does not matter if you use your button or the 4LO lever.

Your car will come with a central differential lock mo matter what. You don't install one.
The only thing you can add is a control button which will help you engage or disengage as you please.
In some situations (pavement, hard surfaces, turns, etc) is better to disengage the CDL when in LO gear.

With the button you can engage it not only in LO but in HI too.
 
I think I got it (the cdl only engages in 4lo otherwise) and see there’s no reason not to install it.

Thanks, received the switch today and will try it this weekend!
 
Back
Top Bottom