Caster question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 19, 2018
Threads
68
Messages
273
Location
carlsbad
Installed new OME 2 1/2" lift with the caster correction bushings. Just got the alinement done and found out I have -.2 Caster. It's a little floaty on the freeway. I bought the medium front springs because I will get a front bumper shortly. My question is after the front has a bumper and sliders will the caster change?
 
we’re the bushings installed properly? You can get castor plates for that lift now too. They are much better than correction bushings.
 
Yes the bushing were installed correctly. That's why I'm trying to figure out why my caster is not on speck. Or is the -.2 ok
 
4035B1D2-1035-4C20-984D-AE10CB2B1C1A.webp
You want positive castor angle as the green line represents in this nifty photo. Negative castor will cause that floaty feel at higher speeds.
 
Had the caster correction bushings at 2.5” ome lift. Negative caster. Just installed caster plates. 3.75-4 positive.

Drives much better. My experience caster bushings are a waste of time. New oem bushings everywhere. Huge diff as well.

Ymmv
 
Yes the bushing were installed correctly. That's why I'm trying to figure out why my caster is not on speck. Or is the -.2 ok
Just curious, but did you have the caster checked prior to installing the bushings? I just purchased the correction bushing but so far I'm not seeing anyone that says it fixed it. To the contrary, most say they have the same or bigger issues after.:frown:
 
I have this same lift and also had negative caster. Decided to buy radius arms from @Delta VS
Have you installed the radius arms yet and did you have the caster checked afterwards to find out the new value. I've been curious about the Delta arms but the $1K price tag immediately puts my curiosity in check. Half that and I'd be sold... if it fixes the problem of course.
 
Have you installed the radius arms yet and did you have the caster checked afterwards to find out the new value. I've been curious about the Delta arms but the $1K price tag immediately puts my curiosity in check. Half that and I'd be sold... if it fixes the problem of course.
No haven't seen them yet. I'm going to a 4 inch lift and cutting and welding in caster plates seemed daunting/permanent. Also shop time is very expensive where I live so finding someone i would trust to weed up the plates would be hard and expensive.Prob add $300 dollars to cost of the kit. So I just splurged on arms.
 
Last edited:
No haven't seen them yet. I'm going to a 4 inch lift and cutting and welding in caster plates seemed daunting/permanent. Also shop time is very expensive where I live so finding someone i would trust to weed up the plates would be hard and expensive.Prob add $300 dollars to cost of the kit. So I just splurged on arms.

Keep in mind that the plates don’t need to be fully welded. Simple stitch welds front and back is all that is needed to keep the plates from shifting while off roaming.
 
Just curious, but did you have the caster checked prior to installing the bushings? I just purchased the correction bushing but so far I'm not seeing anyone that says it fixed it. To the contrary, most say they have the same or bigger issues after.:frown:
I had my caster checked before and after. It helped a tiny bit but I still had negative caster. Wanting 35s and deciding I wanted my driveline to all be in spec is why I went the new radius arms, adjustable upper arms, and a DC front driveshaft
 
Back
Top Bottom