caster correction needed on part time 80?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 2, 2004
Threads
294
Messages
2,745
Location
Hayward, Ca.
Bout to convert my 80 into part time transfer case and needed to replace my ome caster correction bushings-there shot... Wanted to replace them with OEM since I know those sill last a lot longer... But I know I will lose my added caster... How big of a deal is this on a part time rig? I have 4 inches of lift and will not be adding a DC shaft since it will be part time-no vibes only high speeds, just wondering bout the caster correction being necessary. ?.
 
Part time doesn't make you immune to the issues of incorrect caster. It does help with pinion angle induced vibes. You will need correction at your amount of lift. Preferably plates.
 
The caster correction is needed to fix a drive shaft angle issue causing vibrations. With the part-time conversion, your front drive shaft is still turning(unless you do something to add a selectable transfer case). If the front drive-shaft is still spinning, you still need the caster correction.
 
Bout to convert my 80 into part time transfer case and needed to replace my ome caster correction bushings-there shot... Wanted to replace them with OEM since I know those sill last a lot longer... But I know I will lose my added caster... How big of a deal is this on a part time rig? I have 4 inches of lift and will not be adding a DC shaft since it will be part time-no vibes only high speeds, just wondering bout the caster correction being necessary. ?.

Here ya go:
80 Series Caster Correction Plates

Designed for 4" lift and designed to be used with OEM bushings.

With a part time setup I'd recommend doing the caster correction first and see how your driveshaft treats you before making a decision about the DC shaft.
 
Back
Top Bottom