Caster Correction bushings - experince and notes

[lazy]

Most presses will come with the arbor plates that allow you to position them to allow the bushing to pass through. An adjustable saw horse would be helpful with any of the suspension arms. I was a bad boy and just held mine.

SWAG Machined Arbor Press Plates (Pair)

Machined Arbor Press Plates (Pair) Cut out of high strength grade 50-A572 steel plate. These arbor press plates are sold as a pair and are designed to replace the junk cast arbor plates that are prone to shattering under heavy load. Every SWAG arbor press plate is machined on both sides to...

www.swagoffroad.com

I still don't get it. The lip of something like the control arms is 1/8". Then you're trying to hold the end of a 2' arm, balance on the arbor plates and not kill yourself. The radius arms are a bit different, i get that.

Thanks for the swag offroad link, I've been looking at maybe getting a hydraulic brake.

 

[Corbet]

I still don't get it. The lip of something like the control arms is 1/8". Then you're trying to hold the end of a 2' arm, balance on the arbor plates and not kill yourself. The radius arms are a bit different, i get that.

Thanks for the swag offroad link, I've been looking at maybe getting a hydraulic brake.

I found the radius arms to be much more difficult that the rear arms or panards.