Carburetor for a 2F

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2015
Threads
21
Messages
190
Location
SoCal
Hi,

I'm working on my 65, original engine not good so replace it with a 1975 2F.
The question is this: Can i use a pre 9/72 Carburetor on a 2F? since I have cable accelerator not link.

Thanks

Lobsang
 
I'm running a '71 2-bbl. F carburetor on a '76 2F engine. It has the F engine intake and exhaust manifold and air cleaner set-up. I'll be upgrading to an FJ60 electronic ignition with vacuum advance. My two F engine carburetors have been modified to add the vacuum port.
 
If you are asking about using a single-barrel carb on your 2F, then plan on considerable fab. You can bolt a 2barrel-F manifold to a 2F with special head studs/mods. You can bolt a 2-barrel F carb to a 2F manifold. The height of a F manifold mounting surface is different than a 2F. The height of a carbs and insulators might also be a factor? The air cleaner location might be the tough one? There is a threaded rod for mounting the 2F's air cleaner to the air horn, the F's clamps on the outside circumference (which keeps rain making its way thru the window washer on the hood out of the intake manifold and cylinder head).
 
@4Cruisers Did you use a stepped stud set-up on the head / intake manifold, or did you machine/file-out the intake a millimeter?
Here is the stepped stud that 4Cruisers referred to. Unfortunately, I think they are no longer available.

These are used to adapt the smaller diameter stud for the F manifolds to the larger diameter stud for the 2F head.
1570535241015.webp
 
Here is the stepped stud that 4Cruisers referred to. Unfortunately, I think they are no longer available.

These are used to adapt the smaller diameter stud for the F manifolds to the larger diameter stud for the 2F head.
View attachment 2101969
While I was at the Ace Hardware store in Santa Fe and the Do-It-Best Hardware store here in town yesterday, searching for brass screws for an F engine carburetor throttle plate, I looked in the parts drawers for a stud to replace a missing 3FE exhaust manifold stud. In the same drawer as the needed manifold stud I saw stepped studs identical to the one pictured above.
 
Last edited:
Back
Top Bottom