Carbuerator emulsification modification

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 20, 2013
Threads
14
Messages
274
Location
Nemo to Pozo and back to Wyarno
After stumbling on to this interesting do-it-yourself project I did an exhaustive 5 minute search of this site to see if anyone has tried it. I suppose my mechanical side can see the logic behind it, although it also sounds like a good way to compromise factory performance. I wish I had spare parts lying around just to satisfy curiosity.






http://youtu.be/Qmc6_Uhu2Mc
 
The chances of that being true is somewhere between slim and none. The design of the emulsion tubes and the sizes of the fuel and air vent holes are critical to make sure you get the proper air/fuel mixture over the entire operating range of the main nozzles. If you think that the Toyota engineers did a sloppy or lackadaisical job of designing this, then you think their mommas raised fools. When you couple this with the fact that US rules on emissions and corporate average fuel economy, then the chances that a bad design left the Toyota factory are extremely slim. So take your pick of who can design emulsion tubes better: Toyota engineers who need to meet US standards or some yobs dreaming up something with the beer goggles on.

Drilling more holes in that part of the tube seems like it would make it run richer because it is adding more fuel openings without increasing the size of the air bleed.
 
It does actually work but the placement of the holes and the size of the holes is critical. As pin_head said toyota do their research and what they sell to the public is the best option for all situations. With the drilled emulsion tubes the operating angle of the carby is somewhat decreased.
 
While i understand what you guys are saying- I find it kinda ironic on a site that nearly every thread is about modifying something on these things!
 
I could only listen to about 3/4 of that BS. Clearly he doesn't understand how exactly an emulsion tube works to generate a specific fuel curve. Even among expert Weber tuning folks, people who commonly enough drill out jets, their emulsion tubes are a bit of a mystery and are considered to be verboten to drill. It is even a little rare for them to change an emulsion tube from what ever was in the carb to start with, even though there are multitudes of different Weber emulsion tubes. The fuel curve has the be really off for that to be considered.
 
The same principle applies: You can be reasonably sure that the Toyota engineers knew what they were doing when they designed it.

Haha, in most instances I agree; it just seemed funny at the time.
And while generally true, one has to remember a very large part of a manufacturer's design philosophy is ease of manufacture/cost/epa regs/etc. Some things are great, others can be improved upon for a particular purpose.
 
I'm not sure if the youtube bloke knows that the "emulsion tube" he can see is actually a shield around the real emulsion tube. Drilling more holes or enlarging holes will lean the mixture, as the emulsion tube is allowing air down into main well. For the typical USA carb, the mix is either spot on or too lean to start with. Adding more air would be detrimental for anything sold here.
 
Pics of the booster assembly,
then the emulsion tube and shroud removed,
closeup of the emulsion tubes where you may or may not be able to see the tiny holes that air bubbles out of.

DSC08358.webp


DSC08357.webp


DSC08356.webp
 
Last edited:
I watched it and what a crock of chit that is,i thought it was about making the 2F go faster but it was fuel saver mumbo jumbo B.S if i want my 60 to save fuel i will park it in my drive way.Rant over.

Thanks for showing us the tubes Jim,last time i saw those out of the shield was back in the 80's.
 
Back
Top Bottom