carb too far gone!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

65swb45

Elder Statesman
SILVER Star
Joined
Apr 14, 2004
Threads
1,521
Messages
37,613
Location
818-953-9230
Website
marksoffroad.net
Too much booty fab even for me. Mudrak warned me about this carb back in October at GGG. Accel checkball retainer replaced with a wire screen! :doh:
KC02.webp
 
Turns out the wire screen was in there because there isn't enough of the underlying metal in the reservoir for the stock retainer to even grab onto!:eek:

Then I went to pull out the float and realized that the stock steel pin had been replaced with an oversized brass one that is fixed to the air horn!:eek:
KC03.webp
 
Soooo, you'd have to actually spread the two arms on the float to remove and reinstall it onto the air horn. Yes the float arms were drilled out to match the brass pin. Also note from the pic that either the pin wasn't drilled straight, or the arms of the float, because the float sits off to one side, not parallel to the pivot. This makes it highly likely that the float will rub against the side of the float bowl and not move freely up and down, causing mucho problemos.

And take a look at this crispy sight glass:
KC-01.webp
 
This is why I buy cores even when linkages are missing or the throttle shafts are frozen.

Tech note: this is not the first time I've seen a float this crooked. Claudia had this problem on her carb too. If yours looks like this when you take your carb apart, just get a different float.
 
Well I promise you this.. The core I am sending back is brand new compared to the booty fab carb you posted:)
 
Also, BTW Mark my cruiser sold to the first person who looked at it, one week after I put the new carb on it. No joke, it was a great selling point. Your a household name in the Cruiser underworld:cool:
 
dfblackm said:
Mark, I sent you a PM a while back, I have my stock and Asain carb boxed up and ready to send out to you. I just had a couple of questions for you. If you did not get the PM let me know.

Darrin

Found it!:o
 
BTW Mark,
PM me with a rough estimate on rebuilding a 76ish carb that I have sitting around. I want my 72 to be mobile again...


I promise it is in better shape that that one is ;)
 
Back
Top Bottom