Wanted Camino, Ca. GM Tilt steering column

[pardion]

Vehicle Model

1. Other

Looking for a late 60’s or early 70 GM steering column, I’m thinking some of you have removed them to go back to stock Toyota columns. It would have to be tilt and doesn’t matter if it was a column shift or not. Spline on the end is usually 1”. Mine is getting worn out after a few fixes in the last 45 years of hard core wheeling. Thanks, John

 

[kevos37]

John, I have one out in the in the shed.
I'll send you a picture tomorrow.

 

[pardion]

Thanks Kevin

 

[kevos37]

Here is what I have.

 

[pardion]

Do you no what that’s from?

 

[kevos37]

Do you no what that’s from?

No, it was part of a buy.

 

[pardion]

Does it have a splined end where the joint connects to or is that a through bolt?
Can you measure the length from the bottom of the wheel to the end of the hopefully splined end? Thanks

 

[kevos37]

Does it have a splined end where the joint connects to or is that a through bolt?
Can you measure the length from the bottom of the wheel to the end of the hopefully splined end? Thanks

Will do

 

[kevos37]

The measurement from the steering wheel to the bottom of the shaft is 33 and 1/2 in. It is a bolt through end, no spline.

 

[pardion]

Ok, thanks Kevin I think mine is older.
The length sounds good.

 

[pardion]

Still looking, @Vexlo do you have one ?