Broken Manifold Stud

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 7, 2002
Threads
269
Messages
3,148
Location
Pendleton Oregon
Website
www.oregongrain.com
Needed to change the manifold gasket on the FJ45 due to a nasy leak on ALL ports. Long story short all but 3 nuts were cross threaded which in return pulled the studs out of the head. As luck would prevail the stud closest to the fire wall breaks off. I'm going to use a washer, nut and welder to get it out. There is a nub sticking out where I can get a washer and nut on it. I will post up some pics of the extraction.


ps. previous owners blow
 
You gonna replace them all while you're at it?
 
Had to drill one out once on the wife's Volvo. Had broken clean off and of course it was the back exhaust stud. Used a right angle drill and progressively larger bits till I wasclose to the tap drill size. Then I ran the tap in. Worked, but sure was sweating it .
 
chief said:
Heat the manifold with a torch and the stud will come out much easier

Except the stud is in the head. :D
 
If all else fails soak in PB Blaster, then drill the center with a #40 drill bit and use an easy out to get the stud out.
 
I recently read about a special stick welding rod you can purchase for bolt extraction. You would need an arc welder.

The rod is run vertically into the bolt, burns the bolt but does not damage the threads. You let it attach adn cool to the bolt then slip a smaller nut over the stick to aid the extraction.

I couldn't tell you where I read this.....just that it seemed cool. Welding supply store might have more info.

HTH
 
7018 is the right rod to use for a stick welder. Welding a nut on works great and it is faster to get the broken stud out than to set up the welder.

studs.jpg
 
Back
Top Bottom