break lines

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 20, 2006
Threads
139
Messages
4,041
Location
Pequot Lakes MN
I have everything taken apart on my 40, my breaklines look good... how do I tell if I should replace them or just leave them... should I just do it now because it will be easier now than later no matter what they look like?
 
Aaron, get some of these and a tubing cutter and bend your own. You can reuse your fittings.

GL

Ed
engstand.webp
 
If they look even a little bit questionable, replace them. Like you said, you have it apart now. It is a pretty easy job when nothing is in the way. Like Degnol said, buy the bender and cutter and do it yourself. It really isn't that tough.

how do I tell if I should replace them or just leave them

Look in any stressed area (i.e. like in any of the bends) for rusted areas, stress marks, etc. Also look around the fittings for the same things.

Good luck!
 
If you're making from scratch. You'll need one more tool in addition to the ones shown above. An inverted or "double" flare maker. And some tubing to practice on to get them right. It's tricky to make them even with a good tool.
 
Do you have the web site for that tool... I am going to check with my dad I think he has one...
 
checked with my dad he has the two tools Ed (degnol) pictured but I need a double flare maker... who makes a good one...
 
Aaron, I got mine from the local CarQuest for about $27 and it is made in the USA. There are a few little tricks to using any double flare, but if you use them you won't have a problem. I redid all my brake lines without a hitch.

GL

Ed
 
Back
Top Bottom