Braking issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 15, 2003
Threads
102
Messages
3,129
Location
Knoxville
I just notice when I tried to come to a hard stop at a red light that my brakes weren’t completely bringing the vehicle to an immediate stop. The pedal hit a point about half way to the wall that it wouldn’t go any further, but the car was still just eking to a rolling stop.

One thing that may or may not be a factor, a few weeks ago I was coming off the very top of Ski Mountain in Gatlinburg (long decent) and my brakes over heated pretty bad by the time I got to the bottom, smoke, not stopping the car etc.

Is it possible to ruin the pads this way, or do I have some other issue?
 
I would check the pads and make sure they are not glazed over. If they are glazed over just swap them out, easy day. I would check and make sure the rotors are not warped either.

You could also have a failing booster/master. Either the booster/master went out on mine not too long ago so I just replaced both while I was at it. My pedal was rock hard then the next two + pumps of the brake pedal were really soft. Now after replacing the master/booster, stainless lines and a good bleed of the brake system I can lock up my brakes and I am running 35's.
 
Also brake fluid.
 
Also brake fluid.
You'd be surprised how many people never change their brake fluid. I've had more then one customer that thought that their brake fluid was supposed to have that maple syrup color so they could see how much fluid was in their transparent master cylinder.

You should of seen the look on their face when i told them that that maple syrup color came from the fact that their brake system was rusting from the inside out. They were shocked to find out that new brake fluid was in fact clear, and the system should be flushed at least every two years to prevent rust due to the fact that most brake fluid is hygroscopic.
 
One other oddity I’ve noticed now for the second time, when I turn the ignition off after driving, I can feel the brake pedal pushing my foot back up. Does that make sense for anything?
 
One other oddity I’ve noticed now for the second time, when I turn the ignition off after driving, I can feel the brake pedal pushing my foot back up. Does that make sense for anything?

That is the exact same thing that happened when either my master/booster started going out on me.
 
One other oddity I’ve noticed now for the second time, when I turn the ignition off after driving, I can feel the brake pedal pushing my foot back up. Does that make sense for anything?

Booster


I had exact same symptoms and booster fixed it.

You could try just changing the check valve first but that didn't work for me. New boosters dont cone with a new valve so you need one anyway.
 
Booster


I had exact same symptoms and booster fixed it.

You could try just changing the check valve first but that didn't work for me. New boosters dont cone with a new valve so you need one anyway.

I would get a new grommet too, the PN for those are exactly the same as my 98 4Runner Limited.
 
Much to changing them out?

Disconnecting the hard lines at the master, the 4 bolts under the dash, the pin that holds the piston to the brake pedal and wiggling that damn thing in there. While you are at it look into doing the LSPV and ABS delete. My brakes are amazing after doing that modification.
 
Back
Top Bottom