Brakes?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 10, 2006
Threads
99
Messages
501
Location
The Ghetto
I was reading the earlier thread about the booster issue or whatever it turned out to be. I bought a 72 FJ and am picking it up tommorrow. When I originally test drove it I would depress the brake pedal and it would go all the way to the floor but it would slow the LC down not stop it like it should. When I mentioned it to the seller he stated that I might need a new booster. Now, i'm not sure what I need. If that's all that it takes i'd be happy. I want to drive the hell out of this thing but can't because the brakes are screwed. What can I do here
 
Could be a few different things. Does the truck have the original front and rear drum brakes? If so, could be your brake cylinders are badly in need of adjusting. pre-76 cruisers have 2 wheel cylinders at each wheel (total 8) which are not self adjusting and which are something of a PITA to keep adjusted.

Could also be a failing brake master cylinder. Get someone who knows LC brakes to take a look at it. I wouldn't drive it until it's fixed - you could very readily suddenly find yourself with NO brakes, and the LC emergancy brake isn't the best.
 
Verify your fluid levels in the brake master cylinder reservoirs and that you do not have any fluid leaking from the system. Provided that these are all normal, I would then try and adjust the wheel cylinders, as has been stated.

A failing booster is going to give you a very hard brake pedal or an intermittent soft and hard one, but will not have anything to do with the length of travel required to actuate the brakes, provided that someone has not messed with adjustable linkage pieces on the booster.


Good luck!


-Steve
 
Poser said:
Verify your fluid levels in the brake master cylinder reservoirs and that you do not have any fluid leaking from the system. Provided that these are all normal, I would then try and adjust the wheel cylinders, as has been stated.

A failing booster is going to give you a very hard brake pedal or an intermittent soft and hard one, but will not have anything to do with the length of travel required to actuate the brakes, provided that someone has not messed with adjustable linkage pieces on the booster.

Agreed. I did not see this thread before I responded to your PM about the booster. Based on experience, I'd say you're MUCH MORE LIKELY to have a wheel cylinder issue than a booster one.

Do some thread searches, ask some more questions if need be. If it turns out you need a booster, I will be happy to sell you one. Just sounds premature right now.

Best

Mark A.
 
Booster

Mark, I had the seller bring it in to get it checked out and the garage said there was a leak in the booster. So I need a new booster, right? I do hear a hissing when I have it depressed when the engine is on.
 
I just saw this post. I also PM'd you before I got here. Pretty much everthing I said in the PM is already on here. It sounds like your booster is bad. If you have read earlier booster threads, you know that there are lots of options for boosters. However, that still does not explain the braking issue. Still check the things I mentioned in the PM and things mentioned here in this thread.

1. Brake fluid in resorvoir
2. Adjust brakes
3. Bleed brakes
4. Check for leaks in brake system
5. Still no brakes, check M/C

Good luck!
 
Back
Top Bottom