Brake wiring question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 6, 2005
Threads
55
Messages
412
Location
EAST COAST
I am installing a "Painful" wiring harness in my 10/74 FJ40. Almost done everything is working fine.
There are no wires for the brake master cylinder? The original harness had 2, one to each resevoir. What do the wires on the master cylinder do? Do I really need them? If I leave these wires out am I screwing up big time? :confused:
 
The wires detect a pressure difference betwen the front and rear sections of the master cylinder and light the check "Brake" light to alert you to potential leaks and malfunction. Early cruisers dididn't have this feature.
 
You don't need them, there for the brake light on the dash that lets you know if theres a pressure problem. Mine have been disconnected for years and never had a prob.
 
Outstanding, Thats the answer I was hoping for. thank you pin_head and secretagent.
 
That little light on the dash is helpful for me. It lets me know the brakes need adjusting when it comes on. I'm too lazy to adjust my brakes regularly. It's a biatch of a job on a four drum system with two cylinders to adjust per wheel!
 
When it is done regularly, it is really not that big of a deal. They become a pain when they are not adjusted, allowed to freeze up, and or ran in mud and not cleaned. Less than a half hours work...


Good luck!


-Steve
 
I like knowing when I'm driving around with the parking brake on. Too bad it took me 3 years to figure out the wiring on the damn thing.
 
Back
Top Bottom