brake nightmare

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 28, 2006
Threads
19
Messages
100
I replaced the pads and got a spongy pedal. Search here and lead me to bleeding the brakes. Did that and no change. searched some more, replaced master cylinder, tried to bleed the system and now i only get fluid to the back brakes. no fluid what so ever comes out of the lspv or the front brakes. What gives how did I f-up a simple pad change. By the way i did bench bleed the master. Please help no brakes=no fishing trips.
 
no fluid leaking for sure, I'm going to jump back on it tomorrow. It may have to go to the brake shop on Monday, hopefully not.
 
Did you replace the rotors too? If so, check your bearing preload. Loose bearings will cause your pedal to do weird things.
 
Bleed the brakes again, make sure you do the correct order, and don't be afraid to bleed them too much. If you just changed the pads, it has to be air in the system if fluid isn't squirting everywhere. You may have compounded the problem by replacing the MC, but i think if you bleed them properly you should be good. Why did you replace the MC, did you have other problems besides bad pads prior to this?
 
You did bleed the LSPV, right?
 
now i have no fluid coming out of the lspv or front brakes. what gives. ie i can't bleed the lspv or front brakes, rears bleed fine. now using a one vacuum bleeder to no avail.
 
I replaced the pads and got a spongy pedal. Search here and lead me to bleeding the brakes. Did that and no change. searched some more, replaced master cylinder, tried to bleed the system and now i only get fluid to the back brakes. no fluid what so ever comes out of the lspv or the front brakes. What gives how did I f-up a simple pad change. By the way i did bench bleed the master. Please help no brakes=no fishing trips.

What did you replace it with? Reman'd unit? Cardone?
Or new unit?

Also check for clogged bleeders.

With a flared wrench you could pull the hard line to the lspv and see if you have flow to it. Spray some PBlaster or equivelant on the fitting first before removal attempt.
 
You may have a frozen caliper...
Pull your pads, stick some wood where the pads where, this keeps the caliper pistons from popping out and now try your brakes.

If there is no movement you know what the culprit is.

I make it a habit to clean and grease the caliper rubber seals every time I pull a wheel and or check brakes.

Sometimes you really need to apply pressure at the pedal to release a stuck caliper.

If you decide to clean/rebuild the caliper you need to keep an eye on it...easily done by touching all the axles feeling for abnormal heat.

Good luck
 
m/c is a reman asin unit.

I'll try the lspv, but if I'm getting fluid to the rear brakes the lspv should get fluid as well, right?
 
In the interest of getting good recommendations, could you provide us with your bench bleeding proceedure and then how you bled the brakes? There are lots of ways to bleed the brakes: pressure bleeding, vacuum bleeding, gravity bleeding, the "two-person" method. How exactly did you bench bleed the m/c.

When I replace the two front calipers and the front brake lines on the FZJ, I found the two person method provided better results than pressure bleeding. Not sure why, but those were the results. Never had good luck vacuum bleeding. Have gravity bled in another car with very good results. Different brake system though.

I understand your frustration. On one vehicle it took me a couple weeks to solve the problem in getting all the air out !

Keep the Cruiser Faith !!!

R.
 
Last edited:
Back
Top Bottom