block drain bolt stuck

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

davidp14

SILVER Star
Joined
Mar 24, 2017
Threads
23
Messages
1,909
Location
Nelson Co., VA
Wanted to do a coolant flush today but I couldn't get the block drain bolt off. I turned with all my might on my 3/8 ratchet but it wouldn't budge.

Should I try a breaker bar? Maybe a cordless impact? I'm just not sure how much this brass bolt will take before I get into more trouble.
 
May try a penetrant oil for a day or two.

Ive only used a hand ratchet and enough extensions to clear the wheel well. Perhaps a small impact could help; id go lose/tight/lose at first to try and break it lose.
 
Yes drivers side well.

rps20180730_121648.webp


That's wd40. I gave it a squirt before I even tried. I'll switch to pb though.
 
I chewed one up removing it from a block I was not using. If you can't get it then move on or get another one to replace it with. I remember having to tighten the new more than I wanted to get it to stop leaking.
WD40 wont help you here, but it's good for cleaning stuff though.
The old try to tighten then loosening is a good one.
 
Use a Flare Nut Wrench. If you do not have a set, they will help you in the future.
 
Try 1/2 drive with a 6 point socket. You’re accessing it via the driver side wheel well, correct?

Agreed. 3/8" extensions long enough to reach out the wheel well will twist a lot, 1/2" extensions will be much more rigid (though I know it doesn't really make a difference on applied torque if you're using a hand ratchet.) The most important thing is a 6-pt socket so you can apply more torque with less fear of rounding over the head.

Part of the issue is that brass will expand more than iron when evenly heated (e.g. through normal engine heat). This means the plug will tend to seat more tightly into the threads when warm. Probably makes sense from a leak-prevention perspective. One idea, perhaps, (though I've not tried this), is to get the engine up to temp, then chill the plug (and not the surrounding iron) with some cold spray. Just a thought...
 
Back
Top Bottom