Bleeding brakes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 31, 2005
Threads
31
Messages
230
Location
Honolulu, HI
Someone mentioned bleeding the brakes "very carefully". What does that mean? Don't you just press brake,open bleeder, close bleeder, let off brake, repeat? Or did I just total my new taiwanese brake system?
 
"Very carefully" should also mean "very thoroughly."

First, make sure your master cylinder is completely (bench) bled and make sure your brakes are fully adjusted. Otherwise you'll be wasting your time with the rest of the system.

Best done as a two-person job, pump the pedal a number of times to get the pressure up and then hold it before you crack the bleeder open, starting with the wheel furthest down-line from the master cylinder. A steady stream of fluid with no bubbles is what you're looking for.

Also, keep an eye on the fluid level in the MC resorvoir as you're doing this. If it runs dry at any time, then you have to start from scratch. :crybaby: :crybaby:
 
You can also get a Mity-Vac brake bleeder accessory and easily do it yourself. This gizmo allows you to suck the fluid out of the lines or you can reverse it to push fluid into the lines. Works great when you are by yourself! Someone also mentioned self bleeders to replace the stock bleeders. These would allow you to do the same thing with less fuss
 
The Motive Power-Bleeder is another good one.

http://www.4x4wire.com/reviews/motive_bleeder/

You might even be able to "borrow" a power bleeder from one of the auto parts stores' loan-a-tool programs (i.e., Autozone, Advance Auto Parts).
power bleeder.webp
 
There's a thread on speed bleeders if you use the search function. Alot of people have been extremely happy with them.
 
If while trying to bleed them it seems like your getting no-where, go have lunch and try again later. When I replaced master (bench-bled, I thought) and rear disks I had a heck of a time getting the pedal to firm up. Got frustrated went in for a couple hours and came back out, bled perfect. The only thing I can figure is I aerated the fluid with tiny bubbles initially and had to let them "settle up"

The speed bleaders were a great addition too.
 
Hmm, thanks! I guess I didn't break anything! :D
 
Back when I turned wrenches for a living, we always used the two person method for bleeding brakes, even though we had all types of fancy pressure bleeders and gizmos. You could have them bled properly before you got the gizmos out and hooked up. Time is money.
 
Back
Top Bottom