Bad axle?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 9, 2007
Threads
39
Messages
118
Location
Kennedrunksnort Maine
Newbie planning on buying a 96/97 LC or LX -Drove an LX w/97k yesterday-Took issue w/ the 4low when engaged in a parking lot and got alot of chunk, thunk and crunch on driver front on corners(5-10mph tops). Back in hi-range, nothing. After inspecting the axle, it looks like the picks I saw in here of a poster asking if the axle seals were bad needing replacement. my bigger concern is looks/smells like the underbody had been undercoated recently-the dealer said it wasn't him-asked him about the crunch..replied" you never use 4low on dry surface..it'll buck and jump and any mechanic will tell you the same". Not buying it..I have a 93 Montero w/ 230k...never had any issue w/ my low range making that sound. Advice.. thoughts? The LX is great looking besides that..I'm in New England so the body looks good...unless that undercoating was thrown on to disguise lots of warts.
 
Is there a better way to check the integrity of the seals? What would be the best way to test the low end? Why would it chunk on the driver's side and not passenger? The dealer's attitude changed from welcoming to adversary when I started questioning the performance of the front end. Looked like there was a lot of build up around the front end seals-he said after recent full rotor/break job was left over fluids. Not buying the story.
 
Test the drive train on sand or gravel when in low range, the bucking etc relates to axle wind up because your centre diff is "LOCKED"

Seals are an easy fix.
https://forum.ih8mud.com/showthread.php?t=165235

The first two pics are probably evidence of a leaking axle seal, but could also be wrong grease.

The third photo is good except for the lack of grease on the knuckle evidenced by rust lines on the upper 3/4 of the knuckle. If you look closely the bottom 1/4 is swiped with grease.
 
Is there a better way to check the integrity of the seals? What would be the best way to test the low end? Why would it chunk on the driver's side and not passenger? The dealer's attitude changed from welcoming to adversary when I started questioning the performance of the front end. Looked like there was a lot of build up around the front end seals-he said after recent full rotor/break job was left over fluids. Not buying the story.

I'd buy it. The sales person is correct about not driving it on dry ground in Low (easily "fixed" :hillbilly:). And the seals....There is a ton of build up around my seals, but they are just fine.
 
I dunno about thunks and crunching- I've had both of mine in 4 low on pavement and never heard anything but screeching from the tires. I'd look further into that. Nothing in the drivetrain should be thunking or crunching. Especially not crunching.

-Spike
 
Back
Top Bottom