question for you 4 runner guys, my buddy bought an 89 runner and is going to do a SAS. he found an axle from a '79 pick up. wondering if the width was the same from 79-85 and if this axle will work. thanks boys. -VETTE
axle with question
- Thread starter VETTE60
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Joined
- Jan 8, 2006
- Threads
- 265
- Messages
- 9,822
- Location
- Ashland, OR
- Website
- www.jeffersonstatecruisers.com
No, it's about 3 inches narrower... There's a link in the FAQ on using IFS parts to make it wider, or most people just run spacers.
Ummm... I thought all the FRONT axles from '79-85 were the same width, but the earlier ones didn't have the gusseting on the housing from the factory. Is this not correct?
I believe that is what he's asking.
I believe that is what he's asking.
- Joined
- Jan 8, 2006
- Threads
- 265
- Messages
- 9,822
- Location
- Ashland, OR
- Website
- www.jeffersonstatecruisers.com
They are the same 79-85, it's 3 inches shorter than the rear in the 89, I misread the question a little. 55 I think, and 58 for the IFS rear.
Yup and most of the larger SAS kits from Marlin etc. come with wheel spacers and rotors in the front to run IFS calipers. If he is ordering from them make sure he specifies that he has an older axle, so they get him the right rotors.