Auto up/down window modifications?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

would it work if you had a drivers window switch in all 4 window switch buttons?
 
there is a current sensing circuit that only works with the driver's window. It's a circuit board and a solenoid with a latch circuit. It's just not going to happens with the factory switch assembly. Now I do remember seeing a Toyota with auto DS & PS window switches so that might be able to be grafted in but I can't remember where I saw them.
 
I know the new Scions have them both DS and PS. At least in the tC's, which I rode in. IIRC the switches were the same, so you should be able to just pull them out and then figure out how to wire them for a stock look
 
It's definitely possible and I am 100% sure of that. I don't know what exactly you would have to do, but it may be as significant as rewiring the whole deal. It could also be as simple as pulling a switch unit from a Scion (as Bighead suggested).
 
For some reason the last time I typed this out it glitched and didn't load.....

You might also look at ES300's the one I own has driver and passenger side auto up and down controls. Using the same patter that toyota panels us with the same switches as are found in the 80.

And if that isn't cool enough I think that the oak interior colors are close enough that it could be plug and play.
 
Back
Top Bottom