At my wits end. Please help.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 23, 2008
Threads
23
Messages
270
Location
Sunnyslope, Phoenix, Arizona
I have a 91. 3 months ago i started having idle problems. When stopping i lose idle and die. Thru many series of tests i have replaced, fuel filter, T.P.S., cap, rotor, plugs, wires, both 6" main intake rubber hoses, I opened the intake manifold and scrubbed it and the E.G.R., battery, I even found out my alternator was so worn out that it was a serious drag on the engine. After replacing each part the truck would act better then hours later no idle. I have researched this excellent forum for other problems and have had great sucsess. No check engine lights. Please help me out guys.
 
Last edited:
come on guys.
 
Well would have said to try fuel filter first but if you have done that along with everything else have you looked at the fuel pump sock inside the fuel tank? I didn't have this issue in my LX but did in another vehicle.
 
on the "to-check" list

fuel pump sock (thanks XTC)
coil
coil module
 
I had this problem BAD with an Explorer - turned out to be vacuum line - one had come loose - see if you have any sucking noise under the hood when someone stays on the throttle.
:meh:
 
that was first thing i checked. sooo many vac lines on this motor

thanks
 
come on guys.


So nobody answers in 18 minutes and you start to get antsy?

:lol:

3FE engines seem to have fuel pressure regulator issues. I did not note that on your list of replaced/checked stuff.
 
Last edited:
after 3 months with the same problem. hell yeah! im dyin here. ;)
 
Have you tested your fuel pressure? The 3FE changes the fuel pressure at idle via a VSV and the fuel pressure regulator (FPR). Your fuel pressure could be dropping so low that the injectors get starved for fuel. There's a procedure described in the FSM for testing. Basically you hook up a pressure gauge to the fuel rail and monitor the pressure per the FSM. The trick is getting the right banjo fitting to hook up the gauge. When I tested mine a few years back, I disconnected the fuel line running between the fuel rail and the cold start valve and used that as my access point. I just used an inexpensive pressure gauge that I bought at a hardware store; I think it went from 0-60lbs.
 
anywhere i can download the FSM?
 
Awesome. The electrical genious said fuel pressure regulator just like me...

Sometimes I know more than I know......:hillbilly:


Unlike Tom, most of my knowledge is accidental.....
 
anywhere i can download the FSM?

You would probably be better served with a hard copy in fist.

Those can be obtained from the Toyota Material Distribution Center In Torrance CA at 1-800-622-2033.
 
thanks
 
Hey GORDO, trust me, thats the best purchase you can make. There is a download option but its NOT easy and its NOT quick and its NOT in order.
 
thanks alot guys. i appreciate the info.
 
Awesome. The electrical genious said fuel pressure regulator just like me...

Sometimes I know more than I know......:hillbilly:


Unlike Tom, most of my knowledge is accidental.....

Oh I know some things about engine mechanicals too, especially with the mighty 3FE. :grinpimp:

Still ain't worth a darn when it comes to memorizing Toyota part numbers though. :rolleyes:
 
well. i tested my ignition coil last nite and it ohmd bad. just bought a new one. install tonite.
 
GRrrrrrrrr.:mad: Still nuthin :censor:!
 
Back
Top Bottom