Anyone using these MAN-A-FRE sliders?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I like the design and would have considered buying them rather than making mine as I think their design is a bit better (angeled up tubing, reinforcement). but in reading more over the past many months, I wonder if in a design like this (like mine) there is an issue with no tie into the frame. since they are just attached to the rocker panel, it would be better than nothing... but not being tied into the frame makes them less stout and not as true of a slider as I have seen made here by others?

for example, see HawkDrivers model and his tie in to the frame... https://forum.ih8mud.com/showthread.php?t=80211&page=2&highlight=slider

but, I suppose you could add a tie into the frame and it would save time as the slider would be built for you already.

sure someone else will chime in as sliders are a hot topic.
 
Last edited:
Those are okay. A little bit of leverage will be applied to the body though, possibly resulting in bending of the lower body panel lip.
I've got some REALLY old steel steps that I inserted 2x2 steel tubing inside the "lip". work pretty good unless your foot slips on it while getting into the rig (shin basher:crybaby: ) .
 
Last edited:
depending on how they are reinforced on the inside of the rocker make a world of difference.
if you just use washers, your going to have trouble.
if you use bigger pieces of plate, you spread the load out more.
just my .02
 
Back
Top Bottom