Anyone Using a TECO VFD

[1FZj80]

I just purchased a TECO JNEV VFD for my mill. It works awesome and I can finally get rid of my phase converter.

However, I am having trouble setting up the remote frequency input signal to control motor speed.

I can call the Wolf Automation on Monday, but was hoping to get it going this weekend. Anyone using this setup?

 

[ThreeEyedBandit]

I'm using a Yasakawa inverter and found it very simple to wire it up. You have any install pics? I know with mine you have to make sure you set it to remote, but you know that.

Matt

 

[1FZj80]

I can post up some picts tomorrow.

I want the speed/frequency control at the mill. To do this there is a analog signal input that I can use with a potentiometer. But, I need to determine resistance of the pot and to make sure I get the programming of the VFD correct.

Probably best to wait and call Wolf Automation on Monday.