Another rust rack removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 9, 2006
Threads
89
Messages
2,632
Location
Utah
I just removed my factory roof rack this afternoon. I consider myself lucky because it took me no longer than 2 minutes. None of the screws were rusted and I must have had a diligent port monkey install mine because there was silicone surrounding the holes which I believe is the only reason why my nutserts and screws were not rusted.


There is one area on the DS front where the rack footing had rubbed away the paint and it would have been a matter of time before I might have had some rust. But other than that, there was no sign of rust whatsoever.

Joey's recent thread was my main motivation to remove the rack. I had a close call in a parking garage recently and decided no time like Thanksgiving break to remove it.

I am still undecided if I should remove the strips. They seem like they would provide a little bit of protection if I ever strapped anything to my roof.

However, I'd imagine the strips are just as good of a rust catalyst at the rack is.

Should I go ahead and remove the strips while I'm at it?

I kind of feel like I'm taking a shower and putting my dirty pink panties back on if I don't remove the strips too.

I'll post some pics of the final product including bed liner finish when I am done.
 
I would leave the stripes. IMO. They do provide some protection from low garages. Better to rub those than the paint. (Im sure you will be gloing slower than Joey's wife was in that garage, so you would feel/ hear it before any damage.)

my 2 cents.
 
Last edited:
However, I'd imagine the strips are just as good of a rust catalyst at the rack is.

Should I go ahead and remove the strips while I'm at it?

I kind of feel like I'm taking a shower and putting my dirty pink panties back on if I don't remove the strips too.

The strips are glued on (except the end caps, which are screwed in via nutserts). If you remove them, you'll need to remove the glue that holds them down. A big eraser wheel works.

I'm actually considering leaving the strips (with the runners on them) when I remove mine. For extra strength on the roof and to help keep the branches off the roof, as well as the ability to throw light stuff up there and strap it down if I need to.
 
I decided to keep mine on for just such a reason. Better SOME protection rather than none. I just got some Durabak so I will be going with NAY's suggestion and just doing the rack feet area. BTW the paint on mine had rubbed away the paint as well but I only had slight rusting on the nutserts only.
 
What's a port monkey?

I'm can't remember who coined the term port monkey, but It refers to the guy at the port that was drilling and installing racks fresh off the boat from Japan.


All of you have good points to consider. With all the talk about the roof rack causing rust, it seems like the strips would cause it too.

However, since my rack was not rusting near the nutserts I think I will go ahead and leave them on for the reasons already mentioned.
 
You could bedline OVER the strips. Basically seal them.
 
Back
Top Bottom