A/C: Sometimes cold, sometimes not

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 9, 2017
Threads
113
Messages
949
Location
Denver, NC
Hi All -

My A/C sometimes works well and sometimes doesn't... It does not seem to depend on 1) idling or being at speed, 2) outside temp or 3) engine temp. Essentially, it either works well when the truck starts or it doesn't.

While I've turned many a wrench in my time, I don't have gauges and haven't messed with AC at all. Do you guys have suggestions on where to begin trouble shooting based on these symptoms?

Thanks!!!
 
I would say either electrical or the clutch is going out.

On electrical, it does get cooler but just not cold... But sometimes it gets really cold (like ~45 degrees) and others cooler but not nearly cold - this would suggest that electrical is working I think?

On the clutch, that could certainly be it... how would I check that?

Many thanks
 
you will be able to pop the hood and tell when the clutch is engaging or not, your RPM will increase when it does. Also, i would suggest get a gauge to check your freon level, it should be right around 30-40psi. too high or too low will result in compressor not engaging or ac not blowing cold. Check the pressure while the AC on full blast, careful with the leaked freon, you can get frostbite if contact with skin. best of luck.
 
I had the same problem. this worked for me

This is very helpful and could be the issue for sure! Can you enlighten me on where that unit is located? Looks like it's in the dash near the head unit but not sure?

Also, does year model make a difference or do all of them have the controller? Mine's a '97 FYI.

Thanks!
 
Just pulled the panel and checked... they're all good. Anyone have suggestions on where to go next?
 
Just pulled the panel and checked... they're all good. Anyone have suggestions on where to go next?
Mine looked all good too, I pulled that dash 3 times trying to figure out the problem, last time I resolder it and has been good for a year.

If you're getting cold air, sounds like the AC is working properly. When it goes to not as cold, is the compressor still engaged?
 
Mine looked all good too, I pulled that dash 3 times trying to figure out the problem, last time I resolder it and has been good for a year.

Well, I hadn't put the panel back in from last night so I decided to break out the soldering iron and take a shot... Just put the panel back in and it certainly does seem to have made a difference! I'm getting low 40 degree temps out of the vents and it actually feels like it's getting hot when I move the slider all the way over (which also seemed to be an issue).

Not going to call it fixed until I give it a few test drives but I'm cautiously optimistic! Many thanks @Jgrauman for the idea.
 
This AC system sent me in circles the first time because of extra failsafes that I wasn't used to. So if the panel solder isn't your problem you might look into this.

The system cuts out if the engine RPMs are too low (>1000 rpm) if the engine coolant temp is too high or if the refrigerant pressure is too low. I'm not sure of the other cut-off values. Naturally, to add to the fun, the sensors could be bad and there are actually no system problems.

What happened to me was that I had low refrigerant pressure. It was high enough to provide cool air to the cabin, but the system failsafe was cutting out the compressor. Symptoms I was used to for low pressure was a gradual decline of cool air to the cabin, so I was baffled. I dug through the AC schematics and found these fancy failsafes and realized I had a really basic problem: refrigerant leaking through the schrader valves.

Check your system pressure: The only reference I have is the '94 FSM (with R134a) 0.15 MPa (21.75 PSI) to 0.25 MPa (36.26 PSI) on the low pressure side. Or from pure theoretical standpoint: you're looking for the low side pressure that provides the high pressure side with the greatest difference to the low side pressure.


I hope this helps! Good luck!
 
Last edited:
What month was your 93 built? Up to May of 93 was R12 refrigerant. If you are unsure whether or not the charge is correct, that’s where to start.
 
Back
Top Bottom