For Sale 80 Series build parts (lots of new unused stuff)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

1973Guppie

1973Guppie

10 Year 15 Year 20 Year
Joined
Jan 31, 2003
Threads
954
Messages
10,243
Location
"the whale's vagina", CA
Location
United States
IMG_1241.webp
IMG_1242.webp
IMG_1243.webp
IMG_1244.webp
IMG_1245.webp
I need to thin the parts herd badly. So here are some project parts that are up for grabs that I don't plan to use any longer. I am located in Carlsbad, CA, north county san diego. I prefer local pickup but will ship this stuff on your dime. If you would like to send me a label for shipping that is fine as I know shipping rates sometimes vary widely depending on if you have an account, etc.

all parts are plus ship, will combine for shipping, won't haggle on a "shipped" price cuz I always get screwed, will haggle if you are buying a few things. I have already knocked $ off of this stuff and it is brand new.

Altimeter: SOLD
Snorkel Top: SOLD
Flowmaster muffler: SOLD
Autometer boost guage: $60
Autometer Trans guage: $55
Oil catch can: SOLD
Autometer single guage pod: $20
80 Aftermarket alternator (great for trail spare): SOLD
Ritchie in dash compass: $30
Led lights, come with brackets and hardware, I have 2: SOLD
Din tray and bracket, from a 96: $10
Leftover snorkel install stuff (this is the oem stuff taken off when installing snorkel): $10
Antenna up/down switch: $10
 
Last edited:
"Digital temp meter with temp sensor, this fits in the 80 slot and uses a battery for voltage. Just plug in and route the sensor: $20"

what '80 slot' are you referring to? I have a '93, looks like it might fit one of the blanks down by the rear heater switch? Is it a liquid temp gauge or will it work for ambient temperature?
 
Do you have the template for the snorkel?
 
KDXMAN the templates are commonly off and you have to use a file to adjust
I recommend one of two options 1st attached all screws to the snorkel place some white liquid paper or white corrector on the screws and pressson to the fender the 2nd option put kids clay on the approx places and press into it you then use a drill point puncher to press starter hole as for the large hole any hole saw from 80 mm to 84 mm will work fine I personally recommend the 80 mm and filing to appropiste fit
hope this workd for you it does for me
 
Ok thank's
 
You must log in or register to reply here.

Share this page

Back
Top Bottom