Nice. Hope to have mine by Moab.
80 series 4x4 Labs rear bumper kit install friday
- Thread starter lenross1
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #22
for which truck?
Funny, that sounds like a question from my wife. 100 is going to MOAB so it needs armor. The 62 will be stock and sitting at home. Hopefully it will be running by then.
He looks like a wild leprechaun about to take a dump in Lenny's shop.
Bad little leprechaun!!!
Was thinking the same thing. I wish I was good at photoshop. I would have photoshoped him on a toilet.
Land Speeder
InstaH8R
Ya'll crazy.
But look closely and you can see shunt running down my pant
But look closely and you can see shunt running down my pant
- Thread starter
- #28
I like!
- Thread starter
- #29
Got the spindles welded in. also got the swing arms lined up...
- Thread starter
- #30
davegonz did you use the swing arm gas struts on your 4x4labs bumper?
- Thread starter
- #32
Going with T handle pull pin to keep swing outs open since I bent the gas strut mounts after one wheeling trip 
Here is the mounting location I am thinking about:
got the T handle pull pin from Polyperformance for $10. I like the construction and comes apart easy so welding it on won't be an issue for the internals.
Here is the mounting location I am thinking about:
got the T handle pull pin from Polyperformance for $10. I like the construction and comes apart easy so welding it on won't be an issue for the internals.
- Thread starter
- #33
T handle p welded to spindle housing.
open and pin in locked position. I like the way this came out vs the gas strut design.
open and pin in locked position. I like the way this came out vs the gas strut design.
- Thread starter
- #35
Yes it does have a spring in it. It also comes apart for ease of welding.
I have it where the pin will glide over the bumper and pop in the hole. so all I have to do is pull pin to release it when i close it. The 4x4 labs bumper has a curved edge so the pin will not get hung up on the edge of bumper.
If your Kaymar has a 90 degree edge then you may need to pull pin when you are opening swing out to clear bumper. no big deal but can be cured if need be.
Land Speeder
InstaH8R
I used to have a tech thread like this.... but then my mamma got a job!
holy sh*t that is funny.
- Thread starter
- #39
I guess i need to move it to FaceBook for ya to make it
leave these internets and go play with your bumper.
YouTube - Sir Mix A Lot Baby Got Back Best Quality