'74 Transfer Case

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 26, 2006
Threads
111
Messages
293
Location
Longview, Texas
My 74/40 ( manufactured date 11/73) has the stock 3 sp tranny and 3 sp t/c. I am not certain, but I guess it has the 10 spine input gear. Did they go to the 16 spline input gear in the '74 cruisers expect for the ones that were actually manufactured in 74? Will my t/c easily adapt to a stock 4sp tranny or will I need an adapter?

Also is this the same adapter that would adapt to a sm465 or sm420?

I heard the 74 3sp t/c may be "desirable" because its adapability to a 4sd. I'm a little confused.:confused: Thanks for any help.



dogman
 
texas dogman said:
My 74/40 ( manufactured date 11/73) has the stock 3 sp tranny and 3 sp t/c. I am not certain, but I guess it has the 10 spine input gear. Did they go to the 16 spline input gear in the '74 cruisers expect for the ones that were actually manufactured in 74? Will my t/c easily adapt to a stock 4sp tranny or will I need an adapter?

Also is this the same adapter that would adapt to a sm465 or sm420?

I heard the 74 3sp t/c may be "desirable" because its adapability to a 4sd. I'm a little confused.:confused: Thanks for any help.



dogman


The '74 transfer case is ONLY different from the earlier 3sp cases IF it was bolted to a 4 speed from the factory, otherwise it is just a regular 3sp case.

The '74 cases that were behind 4 spd's have the special "transition input gear" that allows one to bolt a 4 spd to a 3 spd case...

Sm420's and 10 spline SM465's only bolt to 3 spd cases, or 4 spd cases with the transition gear. You must also use a plate adapter, as the bolt patterns do not match up at all.

Know that to bolt a 4 spd tranny in your truck, you will need a 4 spd bellhousing, and either a 4 spd tcase or a transition gear to put in your 3 spd case. The clutch slave will also switch to the passenger side.
 
So a 420 or 465 10 spline will mate to my 3 sp t/c, but will still need an adapter to match bolt patterns...correct? Since these are chevy trannys, either one will mate to my sbc with out an expensive adapter kit up front... correct? I already have a chevy bell housing, but that is for the 3 speed tranny. I am guessing I would probably need a different bell housing for say a SM465?

Would the clutch slave also go on passanger side with either 420 or 465?
 
the clutch slave can mount on either side the 4speed bell housing is set up for that you need to use the 3 speed motor mounts you also need the rear bearing modified you can buy one or mike the shaft and have a shop enlarge the center good luck
 
Back
Top Bottom