'67 Transfer shift handle long pin?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 24, 2016
Threads
92
Messages
365
Location
Bainbridge Island, Washington
I don't believe I'm missing any parts, but I am missing some understanding. Why the long pin through the handle, that barely touches the Front Drive Shift button? Is it just to say, 'hey, if you pull this one, you'll probably want to pull that one too"?

IMG_6626.webp
 
That pin should hit the large flange nut on the F.D shaft. It is there to force 4WD when you shift to low range. something is not quite located correctly, there should be less clearance between the F.D and the lever. Hard to say from the angle of the picture, but it looks like the TC lever is too far to the right, the rod doesn't look centered.
 
Hey Arne, I knew you'd chime in! Well, the rod isn't connected at the other end yet- lost the pin apparently (on order). But even that wouldn't move the pin over... I'll reseat the bracket to make sure it's closer to the FD button.
Sure is fun putting this together!
 
Well Brian, what you are doing now, I've just recently done. So it's all fresh in my mind.

Mine is getting close...
 
I thought the pin went behind the big nut? Forcing 4wd in low?
 
I think the issue the OP (Brian) described is that the pin doesn't extend far enough to catch the big nut.
 
Last edited:
There’s enough wiggle room in the lever bracket to make it all happy.
 
thats a sweet 40 and the pin should be there i always removed mine for 2 low came in handy for me
 
Back
Top Bottom