60 Steering wheel removal FAIL

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 17, 2011
Threads
13
Messages
65
Location
Maui
I have been reading through all the posts about fixing horns on the 60's and am trying to get the steering wheel off to get to the copper ring that people are talking about to do the washer trick. I've got the nut backed off to the very top, so when the wheel pops it doesn't smack me in the face, and put a couple of drops of tri flow on there to help. I have been pulling and pulling, with different levels of strength and yanking, and the steering wheel will not budge.
Am I missing something still? I've been at it for a while and am starting to get pissed. This is my first attempt at doing this, my horn doesn't work and neither do the high beams.
any additional tips on this would be awesome!

thanks
/s
 
If the wheel has never been off before, you probably need a puller... Cheap Harbor Freight one will work fine.
 
X2. you're not "supposed" to be able to yank it off, the way they planned it you need to get a puller like mentioned. we just borrow checker's for free, they'll let you do that.
 
sounds like a puller is in order, not sure if it has been off before, but apparently I am unable to do it by hand.

thanks guys
 
When you get the wheel off, you can make the horn work by pulling the little button thingie off the spring on the part of the hub that remains on the steering column and replace it with a spent .22lr case. If it doesn't come up to where the ring will run, heat up the case with a torch and put a drop of solder inside.
 
Try the side to side rocking motion. It has always worked for me.

Dyno
 
I just did this last week. I replaced both the Ring and the spring. You can see the difference between the old spring and new.
IMG_1980.webp
 
And you replace the spring, remember there is a c-clamp holding it in. I could not get it off for the life of me, I finally just pulled really hard and broke the plastic holding it. I super glued it and hope it works.
IMG_1976.webp
 
I have never had to use a puller to get my steering wheel off... I have used a couple of shade tree methods that usually work - The rocking motion (already referred to above), or you could try pounding on it from the back side with the palms of your hand - imagine that you are trying to pound it off toward you. That will usually work if the "pulling" or "rocking" technique does not. Worth a try in any case.

Some autoparts stores will rent you a steering wheel puller if you do not have one. It is a good thing to have in the toolbox anyway. They usually double to pull other components such as the harmonic balancer.

Good Luck!
 
I loosened the nut without totally removing it. That way you wont knock out any teeth once you get it loose. Then tapped the back of the wheel with a rubber mallet. Slow but didnt need to find a puller. Also, once you get it off don't forget to lube up the plate with dielectric grease else you'll just be right back in there in a year or so (depending on how much you honk:rolleyes:).
 
Back
Top Bottom