- Joined
- Jul 23, 2024
- Threads
- 16
- Messages
- 76
Gray, delete it
60 Series Dash Reproduction
- Thread starter TRFarmers
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Any plans to show the 62’s any love?
- Joined
- Jul 22, 2012
- Threads
- 639
- Messages
- 17,560
- Location
- Winter Park, Florida
- Website
- www.cruisermatts.com
They’re still available from Toyota in grey.
I vote delete.
However, it would be cool if you could still beef up the underside to accommodate those who want to mount OEM hardware or are just looking for that OEM look. I'm thinking something like thicker crossmembers and maybe even pilot holes for drilling and locating a drill template on the topside. Admittedly this might only be used by a few shops and DIYers, but it shouldn't significantly increase your tooling costs.
However, it would be cool if you could still beef up the underside to accommodate those who want to mount OEM hardware or are just looking for that OEM look. I'm thinking something like thicker crossmembers and maybe even pilot holes for drilling and locating a drill template on the topside. Admittedly this might only be used by a few shops and DIYers, but it shouldn't significantly increase your tooling costs.
I think the final decision was to keep the holes in place. There is a group buy for these dashes here:
forum.ih8mud.com
The thought is to leave it as close to factory as possible. The metal stamped framing inside of the dash is going to be a direct reproduction, then the eurethane layer and vinyl outer layer are supposed to be stronger than what came on these stock so they will last much longer
The Rust Farmers 60 Series Dash Pad Pre-Order/ Group Buy
I'm Not affiliated with @TRFarmers anything, but I have been talking to him to see if there was any way we could set up a group buy or pre order for the upcoming Dash pads they are producing. After we talked, he set up a link on their site to handle payment and orders so I wouldnt have to do...
forum.ih8mud.com
The thought is to leave it as close to factory as possible. The metal stamped framing inside of the dash is going to be a direct reproduction, then the eurethane layer and vinyl outer layer are supposed to be stronger than what came on these stock so they will last much longer