60 power steer install, last connection

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 9, 2015
Threads
9
Messages
112
Location
Adelaide Australia
IMG_1457.webp
IMG_1455.webp
Hi all

After some advice here, 60 series box, 75 intermediate shaft, 55 column, is this the part I need the 80 series rag joint for? Looks like I'm up for resplining as it's too long?

Cheers
 
I'd get a U-joint. Can the 60 box be mounted further forward?
 
Measure the splines, I used a borgsen joint that fit. The input shaft on a 60 steering box is 17.5mm x 36 splines. a 11/16 - 36 u-joint (.001 smaller) will fit Borgeson Universal Joint. I used
3/4"-DD X 11/16"-36 Spline Part # 014925
Steering U-Joint, Vibration Damper Style, Steel, Natural, PN 034925
And
Column Bearing – 189431 Northern tool $5 for a 2pack (goes in tube of column to keep it from banging) which you should not need to do with the 55 column. Look for a borgeson with both sides splines 11/16 36. Or there might be a toyota In a junkyard with what u need.
 
That steering shaft will collapse, there are two plastic pins holding it in place, it will go shorter and be safer than a fixed shaft.
 
IMG_1458.webp
I can't see any plastic pins in it?

As luck would have it, my mate had a celica uni that is perfect.

Now I need to either move the box or shorten the shaft, moving the box forward is easiest, but it may cause issues with the springs, diff etc?

My 60 box is in pretty much the same pos as all the other ones posted now
 
That inter shaft should be in two parts and therefore collapsible. You should be able to pull both ends and it come apart into two pieces. This will allow you to close the extra distance.
 
I agree that moving the 60 box that far is too far. Make sure it's far enough forward to clear the Tie Rod at full lock, and then modify the shaft as needed.
 
It does come apart, if I cut 100mm out I will lose most of the safety margin?
Hmmmm, didn't think you'd lose that much. Seen a few of these done via the internets but never head of this issue before.
 
Back
Top Bottom