555 TRE grease?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 23, 2007
Threads
52
Messages
652
Location
Va Beach
I got a set of 555 TRE's and the boots are flat, don't seem to have any grease in them except maybe the bare minimum but there are not zerk fittings or a place to install them. What do you do?
 
I think a lot of people use the needle style tip, wedge it in between the rubber bit and pump more grease in. I have only heard of this method and never actually tried it.
 
TREs are no longer meant to be serviced or regreased thanks to the advancements in grease tech. if the boot is torn, replace the boot, add a little grease to inside of boot i suppose for peace of mind.
 
If they are zirkless then they're not meant to be serviced. The boot at that point is to keep what little grease was squeezed out of the spherical joint from coming out and to keep dust, dirt and water from getting in. Just pumping grease into the rubber boot isnt going to keep it lubricated well enough. Also, manufacturers put in the proper quantity and type of grease necessary for the life of the part, putting incompatible or too much grease decreases the longevity of the part, which is why many TRE's are no longer serviceable. People feel the need to grease them during vehicle maintenance and end up over greasing them without realizing it. If they're not seized, loose and sloppy and not broken, leave them be. If the boots are torn and you can find replacements, then remove the old ones, clean the inside. Smear a small dab of grease around the joint and a small dab in the boot...maybe a little less than a tablespoon total..and put the new boot on.
 
If you wanted to, the metal clips or rings that holds the rubber boot on can be pryed up carefully, then add grease; I would not puncture the boot however. FWIW I replaced the torn boots on my original TRE's, added a high content Molybdenum grease, put the new boots on, TRE's back in service. Now at 343,000 miles.

But as mentioned above, you can probably assume they have the correct amount of grease, unless there was some sort of snafu at the factory.
 
Back
Top Bottom