3FE oil pressure question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 22, 2008
Threads
14
Messages
61
Location
Silver Lake, MI
Hi I have a question on a 92 3fe oil pressure relief. Anyway here goes my O.P. is normally around the 2/3's hash at cruise speed but have been noticing at times lately if I kick it down and run up the rpms to say 3.5k pr so the pressure will drop down to the 1/3rd hash and stay there till the revs drop then will usually go the 1/2 waypoint or so and stay there. Is this normal for these to release there and drop that much or am I getting a weak relief spring. Thanx in adavance for any input.
 
It could be as you guessed. But also could be the sending unit or the dash gauge. The best way to find out is hook up a mechanical gauge and test it out in the same conditions. This way you would know what is up.
I have a similar condition on my 1FZ and have found that it is not a week spring, but a dash gauge going bad. I have not taken the time to fix it. Some day when I update the light in the dash I will do the temp gauge mod and install a new oil pressure gauge. I would look into it to fins out what the problem is. If you do not, low oil pressure at higher RPMs could lead to problems you do not want.
 
That was my concern thought possible gauge problem originally to but seems to be working as it always has. when you first accelerate it rises to above the 3/4 mark then then seems to release and drop. I have a mechanical test gauge just need to get an adapter to check hook it up. Just didn't want to wrestle with it if this seemed the norm for the bypass spring.
 
That is not normal behavior. Somewhere there is a problem. You should definitely put your mechanical test gauge on to see if that drop is really an oil pressure drop or if it is your gauge/wiring/sending unit.
 
I have noticed a slight drop in oil pressure when under load at high RPM since my truck was new. As far as I can tell this is normal behavior for my truck. Alternatively, oil pressure will rise slightly when engine braking. Again, in both cases the gauge movement is a needle width.

After 17 years and 200K miles, I don't worry about it anymore.

I wouldn't put too much faith in the stock gauge either. When it's extremely humid out my oil pressure is always higher than normal. Go figure.
 
My needle moves about a half a needles width in most cases. I use to be worried about it, but soon after I rebuilt the engine and nothing change with the addition of a new oil pump I chalked it up to the sending unit.

Funny thing happened after I rebuild the engine. After priming the oil pump and waiting to witness oil coming out from the rockers after staring the engine, nothing!! Talk about scared:doh:
I then jump on Mud and found that not noticing any oil coming out from the rockers was normally observed. So I put the cover back on and I've been driving it ever since. That's about 5000+ ago.

O'yeah, I even shimmed the relief spring in the pump for more pressure.:hillbilly:
 
Back
Top Bottom