3 to 4 speed conversion, drive shaft question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 21, 2010
Threads
12
Messages
48
Location
North Ca
Hello All. I have been reading up quite a bit on the forum about the 3 to 4 speed tranny swap. I appreciate all the information that has previously been put out. I have not been able to find a simple answer with regard to the drive shafts. Instead of lengthening and shortening my current driveshafts that came with the 3 speed, can I find 4 speed shafts and plug them right in ?? FYI, 1970 FJ40 with a 1976 4 speed and Tcase as the replacement. Thanks for any help anybody can offer up.
 
The bolt patterns will be different on the transfer case outputs and the differential flange, earlier cruisers had a smaller bolt pattern. My '76 is the 68.5x60mm pattern.
 
You could change the diff flanges and accomplish this manuever.
 
Redding, would you say changing out the flanges would be the easiest way to go? If I kept the 3spd shafts, aside from a shorter rear and longer front, any more steps? Thanks
 
you can use the 4 speed drive shafts with your existing 3 speed slip joint ends and mate those together and run the driveshafts upside down. slip yoke end at the axle.
all the slip joints have the same splines and you can mix and match
 
You can use a pinion flange made for the four speed or get a flange that is drilled with both sets of bolt holes. Right now I'm using the upper part of the 3 speed shaft attached to the transfer case and the lower portion of the 4 speed shaft. The splines line up and works fine. Gives me the right measurement from transfer to axle. When I do my spring flip I'll put the rest of the 3 speed shaft back on.
 
I'm doing a 3 to 4 speed on a 67 fj40 and got a 4 speed "conversion kit" and got newer larger flanged drive shafts, I can use one 3 speed short end on the newer shaft to connect the new parking brake to the 67 rear end. And the other 3 speed flange to attach to the front axle but then I'm left with the larger flange to attach to the front transfer case output flange that is the smaller bolt pattern. Seller suggested mating the 3 speed flange onto the newer drive shaft end using a conversion u joint that would mate the 2. Any Ideas how to find the right one?
 
I may have found my own solution based on comments from above in this thread, it looks like getting a new Transfer Case FRONT Output Flange with the larger pattern to fit the new driveshaft from cruiser outfitters for less than $40 would be the easiest solution and save messing with removing the u joints.
 
When I got the 3 to 4 speed conversion kit it came with a new emergency brake set up that has the larger pattern that will mate with the larger flange patterns of one of the drive shafts that came with the kit.
 
Back
Top Bottom