1997 fj80 bad acceleration problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Hey all,
Just bought a code reader and I’m pulling 3 codes:

P0130: O2 sensor circuit malfunction (Bank 1 sensor 1)

P0141: O2 sensor heater circuit malfunction (Bank 1 sensor 2)

P0401: EGR flow insufficient

Thanks ahead for any insight
I had a very similar issue a couple months ago and ran those same 3 codes. I changed the O2 (sensor 1) and replaced my EGR. I also replaced my catalytic converters with a straight pipe (290k on the original cats). It has never run better. I'm not sure the cat delete was necessary but I can definitely tell a difference in acceleration.
 
Get some denso O2 sensors, do the quick vacuum test to make sure your EGR modulator is working, then test your VSV. PM if you want details on this I just went through this for 3 weeks with the code and inspection in Texas, I can explain it quickly.
 
Hey all,
Haven’t posted in a while because I’ve been troubleshooting. Replaced fuel filter, still same problems. I also removed the cats to no avail. I deleted the codes to see if they’d reappear and they haven’t. Also cleaned out the egr. What are all of the possible problem that are left? Thanks
 
O2 sensor, upstream. Maybe downstream while you’re under there. Do the vacuum test on the egr to confirm good. Post results.
 
Hey guys,

Thanks for all of the help with the truck. I ended up biting the bullet and buying a new downpipe and both new cats. I also replaced the O2 sensors and it’s never run better! Thanks again for all the help.
 
Back
Top Bottom