For Sale 1994 FZJ80 locked, 3-link, armored, etc.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

IMG_0016.webp
IMG_0045.webp
0802141344.webp
About 130K on 3rz w/ D44 HP and Waggy Knuckles, Arb in the front, factory locker in the rear, she's got some dents from tree rub, but I DD it every day to work no problem.
 
Oh yea should have added a little more on my taco, its geared with 4.88s and will run 75 no problem on flat freeway no death wobble or anything. Also it has a crawl box as well which makes the truck amazing to play with along with arb compressor on board. Warn 9.5ti that I just replaced all the solenoids in with synthetic line, but I believe those are most the high points. I wouldn't think twice about driving it from Omaha to Nevada as it really does travel well and it built to wheel once it arrives at the destination and turn around and drive home.
 
Nice looking Taco, but looking for cash first. Keep you in mind however.
 
Nice rig. Looks like Booger Weldz old 3 link setup. How's it drive? Compared to conventional control arm setup?
 
Is there some body damage on the driver's side rear quarter panel? Do you have a better image of that area you could post?
 
Nice rig. Looks like Booger Weldz old 3 link setup. How's it drive? Compared to conventional control arm setup?

On the road it's more comfortable, and on washboard or whooped roads there is no comparison it sucks up the little stuff and the big stuff. It also flexes much better than stock, (see next comments.) I usually don't even lower my tire pressure.

Is there some body damage on the driver's side rear quarter panel? Do you have a better image of that area you could post?

Good eye. With the increased flex of the suspension the previous owner flexed it enough to grab the flare on that corner, so yes there is a small crease. It is not impact damage.

P1080393.webp
 
Silly question, but, what do you do for a spare? Loving this rig!!!
-Greg
 
I have a 5th tire and wheel (never been mounted on the Cruiser), and all the fabricator parts to make a dual swing out. HD spindles, tire mount, NATO can brackets, etc. just need to add the structural steel and time to make em...parts included with price listed!
 
Last edited:
Back
Top Bottom